Pioneer S-ST606 WL5 서비스 매뉴얼 - 페이지 2
{카테고리_이름} Pioneer S-ST606 WL5에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer S-ST606 WL5 6 페이지.
페이지 인쇄1
1. FOR PRECAUTION OF REASSEMBLY AND DISASSEMBLY
A
1.1 CS Assy (Front, Surround)
GRILLE
The grille is attached to the cabinet by its bosses applied with
adhesive.
To detach it, pry it open by inserting a flat blade screwdriver
into lower right and lower left slot.
To attach it, apply adhesive to the holes on the baffle. Then
press it to the baffle.
B
CAUTION
In order to prevent the bosses of the grill breaking, be sure to
insert a flat blade screwdriver from just beside of its bosses.
Refer to the drawing (page 4).
WOOFER
The woofer is attached to the baffle by 4 external screws.
To detach it, unfasten those screws.
To detach it, first remove the grille. Then remove the screws.
C
When attaching it, face its terminal upward.
TWEETER
The tweeter is attached to the baffle by 3 external screws.
To detach it, unfasten those screws.
To detach it, first remove the grille. Then remove the screws.
When attaching it, face its terminal leftward or rightward.
D
1.2 CS Assy (Center)
GRILLE
The grille assy is attached to the cabinet by 8 external screws.
To detach it ,unfasten those screws.
SPEAKER UNIT
The speaker unit, together with the grille assy, is attached to the
cabinet by 4 external screws.
To detach it, first remove the grille assy. Next remove the cabi-
E
net. Then remove the cable.
When attaching it, face its terminal toward the input terminal.
F
2
1
2
COSMETIC PANEL
The cosmetic panel is attached to the baffle by its bosses.
To detach it, pry it open by inserting a flat blade screwdriver
into lower slot.
To detach it, first remove the speaker stand base and grille.
Then remove the cosmetic panel.
When attaching it, fit the boss into the hole on the baffle.
SPEAKER STAND BASES
The speaker stand base is attached to the bottom of cabinet by 3
external screws.
To detach it, unfasten those screws.
Attach the speaker stand bases to the stems using the screws
provided. Once you have aligned the stem and base, secure
with the small screws at the points shown below. Note that the
speaker should face in the direction of the base of the isosceles
triangle (outlined below).
S-ST606
2
3
Rear
Stem
(the bottom of cabinet)
Front
Speaker Stand Base
3
4
4