Pioneer S-VSL6C 운영 지침

{카테고리_이름} Pioneer S-VSL6C에 대한 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer S-VSL6C 4 페이지. Pioneer s-vsl6c: operating instruction
Pioneer S-VSL6C에 대해서도 마찬가지입니다: 운영 매뉴얼 (13 페이지)

페이지 인쇄

S-VSL6C

Thank you for buying this Pioneer product. Please read through these

operating instructions so you will know how to operate your model

properly. After you have finished reading the instructions, put them

away in a safe place for future reference.

Accessories

Speaker stand .................................................................................. 1

Mounting fixtures ............................................................................. 1

Safety wire ....................................................................................... 1

Anti-slip pads ........................................................................... 1 (set)

Speaker stand pads (3 types) .......................................................... 1

Screws ............................................................................................. 7

Washers ........................................................................................... 2

Self-adhering fastener (hook strip) .................................................. 2

Self-adhering fastener (loop strip) ................................................... 2

Operating Instructions ..................................................................... 1

Quick Tip

A speaker system's sound characteristics will change

depending on the environment and conditions under which the

system is. A speaker system can be used without problem

immediately after purchase, but its design performance

characteristics will be best demonstrated after breaking them

in by playing music for several dozen hours.

Before you start

• The nominal impedance of this speaker system is 6 ohms.

Connect the speaker system to an amplifier with a load

impedance ranging from 4 to 16 ohms (a model with

"4 – 16 Ω" displayed on the speaker output terminals).

In order to prevent damage to the speaker system resulting from

input overload, please observe the following precautions:

• Do not supply power to the speaker system in excess of the

maximum permissible input.

• When connecting or disconnecting anything in your AV system,

make sure the amplifier is switched off.

• When using a graphic equalizer to emphasize loud sounds in

the high-frequency range, do not use excessive amplifier

volume.

• Do not try to force a low-powered amplifier to produce loud

volumes of sound (the amplifier's harmonic distortion will be

increased, and you may damage the speaker).

Caution: installation

• Do not place the speakers on an unstable surface. It could

present a hazard if it falls, as well as damaging the equipment.

• Switch off and unplug your AV equipment and consult the

instructions when connecting up components. Make sure you

use the correct connecting cables.

• The speaker system grill cannot be removed. Do not try to

forcibly remove it since doing so may damage the grille.

SPEAKER SYSTEM

Caution: in use

• Don't use the speakers to output distorted sound for long

periods of times. This can result in a fire hazard.

• Do not sit or stand on the speakers or let children play on the

speakers.

• Do not put large or heavy objects on top of the speakers.

Connecting Speakers to Amplifier

1 Disconnect the power cord to the amplifier.

2 Use speaker wire to connect the input terminals on the rear panel

of the speakers to the amplifier's speaker output terminals.

Connect the hot-side speaker wire to the + speaker output

terminal; connect the common-side speaker wire to the - speaker

output terminal.

1. Remove insulation at end of wire and twist

ends of wire strands.

2. Loosen the terminal screw and insert the

twisted wire into the hole, then tighten the

terminal screw securely.

When using the supplied speaker stand in a horizontal

installation, pass the speaker wire through the speaker

stand before connecting. When mounting vertically, pass

the wires through the mounting fixture before connecting.

Connect the common-

side speaker wire to the -

speaker output terminal.

OPERATING INSTRUCTIONS

Black -

Connect the hot-side

Red +

speaker wire to the +

speaker output

terminal.