Pioneer SX-X360 사용 설명서 - 페이지 17

{카테고리_이름} Pioneer SX-X360에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer SX-X360 35 페이지. 5.1ch surround system

페이지 인쇄

Getting started

If the receiver subwoofer is off, press

RECEIVER to turn the power on.

Press MCACC .

Try to be as quiet as possible after pressing MCACC. The

volume increases automatically and the system outputs

a series of test tones.

• To cancel Auto MCACC setup before it has finished,

press MCACC. The unit will continue to use the

previous settings.

• If the ambient noise level is too high, NOISY blinks in

the display for five seconds. To exit and check the

noise levels

, press MCACC, or to try again, press

ENTER when RETRY shows in the display.

• If you see an ERR MIC or ERR SP message in the

display, there may be a problem with your mic or the

speaker connections. To try again, press ENTER

when you see RETRY

When the MCACC setup is complete, the volume level

returns to normal, COMPLETE

Acoustic Calibration EQ is activated.

Note

1 • If the room environment is not optimal for the Auto MCACC setup (too much ambient noise, echo off the walls, obstacles blocking the speakers from

the microphone) the final settings may be incorrect. Check for household appliances (air conditioner, fridge, fan, etc.), that may be affecting the environ-

ment and switch them off if necessary.

• Some older TVs may interfere with the operation of the mic. If this seems to be happening, switch off the TV during Auto MCACC setup.

2 If this doesn't work, press MCACC, turn off the power, and check the problem indicated by the ERR message, then try the Auto MCACC setup again.

3 If COMPLETE doesn't appear, it is likely an error occurred during the setup. Please check all connections and try again.

4 See Listening with Acoustic Calibration EQ on page 20 to switch on/off Acoustic Calibration EQ.

shows in the display, and