Pioneer PDP 433CMX 사용 설명서 - 페이지 14
{카테고리_이름} Pioneer PDP 433CMX에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer PDP 433CMX 44 페이지. Pioneer 3rd, 4th % 5th generations plasma panel quick reference parts lists
Pioneer PDP 433CMX에 대해서도 마찬가지입니다: 빠른 참조 부품 목록 (12 페이지)
페이지 인쇄
Part Names and Functions
Operating range of the remote
control unit
When operating the remote control unit, point it at the
remote sensor (Î) located on the front panel of the
main unit. The remote control unit is operable up to 23
feet (7 m) from the unit and within a 30 angle on each
side of the sensor.
7 m (23 feet)
30˚
If you are having difficulty with operation of
the remote control unit
¶ The remote control unit may not operate if there are
objects placed between it and the display.
¶ Operational distance will gradually become shorter as the
batteries begin to wear out; replace weak batteries with
new ones as soon as possible.
¶ This unit discharges infrared rays from the screen. Placing a
video deck or other component that is operated by an
infrared remote control unit near this unit may hamper that
component's reception of the remote control's signal, or
prevent it from receiving the signal entirely. Should this
occur, move the component to a position further away from
this unit.
¶ Depending on the installation surroundings, this unit's
remote control unit may be influenced by the infrared rays
discharged from the plasma display, hampering reception of
its rays or limiting its operational distance. The strength of
infrared rays discharged from the screen will differ
according to the picture displayed.
8
En
30˚
Remote Sensor
Connection Panel
The connection panel is provided with two video input
jacks and one video output jack. Audio input and speaker
output jacks are also provided, together with a CONTROL
IN/OUT connector for connecting to PIONEER
components bearing the Î mark.
For instructions regarding connections, consult the pages
noted in parentheses by each item.
1
SPEAKER (R) terminal
For connection of an external right speaker.
Connect a speaker that has an impedance of 8 -16
(page 14).
2
CONTROL IN/OUT (monaural mini jacks)
For connection of PIONEER components that bear the
Î mark. Making CONTROL connection enables
control of this unit as a component in a system
(page 15).
3
COMBINATION IN/OUT
DO NOT MAKE ANY CONNECTIONS TO THESE
TERMINALS.
These terminals are used in the factory setup.
4
RS-232C
DO NOT MAKE ANY CONNECTIONS TO THIS
TERMINAL.
This terminal is used in the factory setup.
5
INPUT1 (mini D-sub 15 pin)
For connection of a personal computer (PC) or similar
component. Make sure that the connection made
corresponds to the format of the signal output from
the connected component (pages 12 to 14).
6
OUTPUT (INPUT1) (mini D-sub 15 pin)
Use the OUTPUT (INPUT1) terminal to output the
video signal to an external monitor or other
component.
Note: The video signal will not be output from the
OUTPUT (INPUT1) terminal when the main power of
this unit is off or in standby mode.
(page 13)
7
INPUT2 (BNC jacks)
For connection of a personal computer (PC) or similar
component. Make sure that the connection made
corresponds to the format of the signal output from
the connected component (pages 12 to 14).