Ariston AS100 사용자 지침서 - 페이지 7
{카테고리_이름} Ariston AS100에 대한 사용자 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston AS100 14 페이지. Ariston dishwasher
페이지 인쇄
Turning on the Appliance
Starting a wash cycle....
1. Make sure that the plug for the appliance is inserted into
the wall socket.
2. Make sure that the water supply is turned on to full
pressure.
3. Load the dishwasher (see the section entitled, "Loading
the Dishwasher").
4. Pour in the detergent (see the section entitled, "Salt,
Detergent and Rinse Aid").
5. Turn the knob located on the right of the control panel in
the clockwise direction until the number or symbol for the
cycle setting is aligned with the reference mark (see the
section entitled, "Wash Cycle Table").
6. Press the ON-OFF botton, and the ON-OFF light will turn
on. At this point, the wash cycle will begin.
Cancelling or modifying a wash cycle setting...
Premise: A cycle that is underway can only be modified if it has
only been running for a short time. Otherwise, the detergent may
have already been used, and the appliance may have already
drained the wash water. If this is the case, the detergent dispenser
must be refilled (see the paragraph entitled, "Loading the
Detergent").
Wash Cycle Adjustment Buttons
PLUS 65°C Button
This button (see "Close-up View - Control Panel", letter
"E") is used with the normal cycle in the case where pots
and pans with dry caked-on food must be washed.
This is not recommended for delicate items in so far as the
high temperatures could make their surfaces opaque or
lighten decorative colors after repeated washing.
GB
Press the ON-OFF button, and the ON light will turn off.
Rotate the knob in the clockwise direction to the desired
cycle setting (see the section entitled, "Starting a wash
cycle..."). Then, turn the dishwasher back on using the ON-
OFF button.
If you forget to load some of the dishes...
The wash cycle can be interrupted by pressing the ON-OFF
button. You can then load additional dishes and turn the
appliance back on. The cycle will start where it left off.
At the end of the wash cycle...
When the knob stops turning and is aligned with a STOP
mark (see figure), the cycle has
finished. Turn off the appliance using
the ON-OFF button, turn off the water
supply and open the door of the
dishwasher.
Wait a few minutes before unloading
the dishwasher to avoid handling the
dishes and utensils while they are still hot and more
susceptible to breakage. They will also dry better.
Rapid 50°C Button
This button (see "Close-up View - Control Panel", letter
"F"), when pressed with wash cycle 4 (glassware) makes it
possible to run the wash cycle at a lower temperature (50°C)
and eliminates the drying phase.
6
STOP