Pioneer SD-T292 RD/Q1 사용 설명서 - 페이지 22

{카테고리_이름} Pioneer SD-T292 RD/Q1에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer SD-T292 RD/Q1 25 페이지. Hi-fi monitor receiver

페이지 인쇄

TROUBLESHOOTING

if you should experience trouble with your Hi-Fi Monitor Receiver, perform the following checks before consulting a PIONEER authorized ser-

vice center. The problem may lie with a mistake in operating the display. Also, the trouble may be the result of causes outside the display

itself. When checking the display, also check all other video components and electrical appliances being used at the same time.

if you cannot solve the problem yourself after checking the items listed below, then contact the nearest PIONEER authorized service center

or your dealer.

PROBLEM

POSSIBLE CAUSES

AND ADJUSTMENTS

NO PICTURE.

Power plug is disconnected:

Make sure the power cord is plugged in securely.

MAIN POWER switch is off:

Turn on the MAIN

POWER switch, then press the TV POWER switch on the remote control

unit or the POWER ON switch on the Hi-Fi Monitor Receiver.

COLOR

IS WASHED

OUT.

Piug connected to Video Input terminal is disconnected:

The COLOR is not adjusted correctly:

Connect plugs securely.

Adjust COLOR according to PICTURE ADJUSTMENT.

| POOR COLOR TINT.

The TINT is not adjusted correctly:

Adjust TINT according to PICTURE ADJUSTMENT.

STATIC SPOTS

IN PICTURE

GHOST

IMAGES ON THE

SCREEN

COLORED

STRIPES ON THE

SCREEN.

PICTURE IS UNCLEAR.

Noise interference from automobiles or neon signs is influencing the TV reception:

Try changing the height or direction of the TV antenna, or move the antenna farther away

from roads.

The television antenna is receiving signals along two paths. This is called "multipath distortion',

signals are entering the antenna directly, and also after being bounced off nearby tall buildings or

mountains. Or, the direction of the antenna may have been changed by strong winds:

Try changing the height and direction of the antenna.

Interference is being received from other radio or TV signals:

Try changing the height and direction of the antenna. Try changing to a coaxial VHF antenna

cable, since this kind of cable is jess likely to be influenced by other signals.

The plug connected to the Video Input terminal is loose:

Connect all plugs securely.

The TV antenna or antenna cable may be worn out, cut, or otherwise damaged:

Check the antenna and cable for wear or damage. Replace them if necessary.

POOR PICTURE OR COLOR

QUALITY

When an optional speaker system installed near the Hi-Fi Monitor Receiver is moved, the monitor

is receiving interference from the speaker system:

install the Hi-Fi Monitor Receiver farther away from the speaker system. Set the Hi-Fi Moni-

tor Receiver MAIN POWER switch to off, wait for one hour, then turn it on again.

REMOTE

CONTROL

UNIT

DOESN'T FUNCTION.

if a strong fluorescent or other light strikes the remote control sensor, the built-in microcomputer

may malfunction:

Change the position of the Hi-Fi Monitor Receiver and your room lighting. Replace both bat-

teries together about once every six months.

WHEN

TURNING

POWER

ON, A

DIFFERENT CHANNEL

DISPLAYED:

FROM THE

CHANNEL

BEFORE TURNING

POWER

OFF.

the wall outlet within one minute after switching to the desired channel:

Don't turn off the MAIN POWER switch until about 3 seconds have elapsed after changing

Either the MAIN POWER switch was turned off, or the power cord plug was disconnected from

channels. This holds true aiso for changes in sound volume and function selector.

TV BROADCAST

1S NOT

RECEIVED.

The channel plan selector is not in the correct position.

Check the channel allocation, (See pages 14.)