Ariston LI 670 수리 매뉴얼 - 페이지 12

{카테고리_이름} Ariston LI 670에 대한 수리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston LI 670 33 페이지.

8. SOAP DISPENSER and WATER TEMPERATURE NTC

• To remove the Soap Dispenser (Fig. 8-1), first remove the Actuator Solenoid wiring and then the six (6) Phillips screws that mount

the Dispenser to the Inner Door. The Dispenser can then be removed and replaced as a complete assembly.

OPERATION: The Actuator Solenoid is energized twice during a complete cycle. The first actuation releases the Detergent and

also aligns the Dispenser Linkage for the second actuation which releases the Rinse Agent.

TECH NOTE: Located on the upper right corner of the Dispenser is the Water Temperature NTC. The NTC is hard wired to the

Main Control Board. If the NTC proves faulty the Main Control Board must be replaced. Also, Dishwasher Models

L63 / LL64 / LI 640 / LI 670 incorporate a Magnetic Reed Switch to activate the Rinse Aid LED. Models LL 65 &

LI 700 use a Turbidity Sensor, see Section 19 for details.

• To adjust the tension on the Outer Door turn the two (2) 5mm Allen Screws Clockwise for

more spring tension and Counter Clockwise for less spring tension (Fig. 9-1).

• The Door Latch can be adjusted using a 7mm Nut Driver (Fig. 9-2)

REPAIR MANUAL

L 63 / LL 64 / LL 65

LI 640 / LI 670 / LI 700

Fig. 9-1

Fig. 8-1

Fig. 9-2

Page: 7