Ariston LIE2C19 A 일일 참조 매뉴얼 - 페이지 7
{카테고리_이름} Ariston LIE2C19 A에 대한 일일 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston LIE2C19 A 9 페이지.
페이지 인쇄TROUBLESHOOTING
Your dishwasher may not work properly.
Before contacting the Service Centre check if the problem can be solved by going through the following list.
PROBLEMS
POSSIBLE CAUSES
The dishwasher
The appliance has not been plugged in
won't start or does
properly.
not respond to
commands.
Power outage.
The dishwasher door is not closed.
It does not respond to commands.
The dishwasher
The wash cycle has not finished yet.
won't drain.
The drain hose is bent.
The sink drain pipe is blocked.
The filter is clogged up with food residues
The dishwasher
The dishes are rattling against each.
makes excessive
noise.
An excessive amount of foam has been
produced.
The dishes are not
The crockery has not been arranged
clean.
properly.
The spray arms cannot rotate freely,
being hindered by the dishes.
The wash cycle is too gentle.
An excessive amount of foam has been
produced.
The cap on the rinse aid compartment
has not been shut correctly.
The filter is soiled or clogged.
There is no salt.
MAINTENANCE AND TROUBLESHOOTING GUIDE
For more information, maintenance procedures and troubleshooting,
see the Use and Care Guide.
The Use and Care Guide can be obtained by:
• After-Sales Service; phone number see in warranty booklet.
• download from website: www.aristonbrand.com
• use QR code
SOLUTIONS
Insert the plug into the socket.
The dishwasher starts automatically when the power returns.
Vigorously push the door until you hear the "click".
Switch off the appliance by pressing the ON/OFF button, switch it back on
after approximately one minute and reset the program.
Wait until the wash cycle finishes.
Check that the drain hose is not bent (see INSTALATION INSTRUCTION).
Clean the sink drain pipe.
Clean the filter (see CLEANING THE FILTER ASSEMBLY).
Arrange the crockery correctly (see LOADING THE RACKS).
The detergent has not been measured out correctly or it is not suitable for
use in dishwashers (see FILLING THE DETERGENT DISPENSER). Reset dish-
washer by pressing the DRAIN button (see OPTIONS AND FUNCTIONS) and
run new program without detergent.
Arrange the crockery correctly (see LOADING THE RACKS).
Arrange the crockery correctly (see LOADING THE RACKS).
Select an appropriate wash cycle (see PROGRAMS TABLE).
The detergent has not been measured out correctly or it is not suitable for
use in dishwashers (see FILLING THE DETERGENT DISPENSER).
Make sure the cap of the rinse aid dispenser is closed.
Clean the filter assembly (see CARE AND MAINTENANCE).
Fill the salt reservoir (see FILLING THE SALT RESERVOIR).
CONTACTING AFTER-SALES SERVICE
When you contact the After-Sales Service,
you must provide the codes shown on
the rating plate attached to the left or
right side inside the door of the
dishwasher. The phone number is listed
in the warranty booklet.
EN
IEC 436
:
7