Ariston 3700709 조립 및 작동 지침 매뉴얼 - 페이지 35

{카테고리_이름} Ariston 3700709에 대한 조립 및 작동 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston 3700709 48 페이지.

페이지 인쇄

LEGIONELLA BACTERIA FUNCTION

Legionella are small rod shaped bacteria which are a natural constituent of all fresh waters. Legionaries'

disease is a pneumonia infection caused by inhaling of Legionella species. Long periods of water stagna-

tion should be avoided; it means the water heater should be used or flushed at least weekly.

The European standard CEN/TR 16355 gives recommendations for good practice concerning the preven-

tion of Legionella growth in drinking water installations but existing national regulations remain in force.

This electro-mechanical storage water heater is sold with a thermostat set at a temperature higher than

60°C; it means it is enabled to carry out a "thermal disinfection cycle" to restrict the Legionella growth

inside the tank.

Warning: when this software has been carrying out the thermal disinfection treatment, water temperature

can cause burns. Feel water before bathing or showering.

TECHNICAL CHARACTERISTICS

For the technical specifications, refer to the nameplate (the nameplate is located next to the water in-

take/outlet pipes).

Product range

Weight

Installation

Model

Volume available

The appliance is conforming with international electrical safety standard IEC 60335-1;

IEC 60335-2-21.

Electromagnetic compatibility (EMC): EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3.

This product is in conformity with REACH regulations.

This product is a device that must be installed vertically in order to operate correctly. Once installa-

tion is complete, and before any water is added or the power supply is connected, use a measuring

instrument (i.e. a spirit level) to check that the device has been installed perfectly vertical.

The appliance heats water to a temperature below boiling point. It must be linked up to a mains water

supply according to the appliance performance levels and capacity.

Before connecting the appliance, it is first necessary to:

- Check whether the characteristics (please refer to the data plate) meet the customer's requirements.

- Make sure the installation conforms to the IP degree (of protection against the penetration of liquids)

of the appliance according to the applicable norms in force.

- Read the instructions provided on the packaging label and on the appliance data plate.

This appliance was designed to be installed only inside buildings in compliance with the applicable

norms in force. Furthermore, installers are requested to keep to the following advice in the presence of:

- Humidity: do not install the appliance in closed (unventilated) and damp rooms.

- Frost: do not install the appliance in areas where the temperature may drop critically and there may

be a risk that ice may form.

- Sunlight: do not expose the appliance to direct sunrays, even in the presence of windows.

- Dust/vapours/gas: do not install the appliance in the presence of particularly dangerous substances

such as acidic vapours, dust or those saturated with gas.

- Electrical discharges: do not install the appliance directly on electrical supplies that aren't protected

against sudden voltage jumps.

TABLE 1 - PRODUCT INFORMATION

Vertical

INSTALLING NORMS (for the installer)

17,5

Vertical

Refer to the nameplate

100

27,5

Vertical

35 / EN