Ariston 80 Multis 설치, 사용, 유지보수 지침 - 페이지 13

{카테고리_이름} Ariston 80 Multis에 대한 설치, 사용, 유지보수 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston 80 Multis 41 페이지.

GENERAL SAFETY INSTRUCTIONS

1. Read the instructions and warning in this manual carefully,

they contain important information regarding safe installa-

tion, use and maintenance.

This manual is an integral part of the product. Hand it on to

the next user/owner in case of change of property.

2. The manufacturer shall not liable for any injury to people, ani-

mals or damage to property caused by improper, incorrect or

unreasonable use or failure to follow the instructions reported in

this publication.

3. Installation and maintenance must be performed by profession-

ally qualified personnel as specified in the relative paragraphs.

Only use original spare parts. Failure to observe the above in-

structions can compromise the safety of the appliance and re-

lieves the manufacturer of any liability for the consequences.

4. DO NOT leave the packaging materials (staples, plastic bags,

expanded polystyrene, etc.) within the reach of children - they

can cause serious injury.

5. The appliance may not be used by persons under 8 years of

age, with reduced physical, sensory or mental capacity, or lack-

ing the requisite experience and familiarity, unless under super-

vision or following instruction in the safe use of the appliance

and the hazards attendant on such use. DO NOT permit children

to play with the appliance. User cleaning and maintenance may

not be done by unsupervised children.

6. DO NOT touch the appliance when barefoot or if any part of

your body is wet.

7. Before using the device and after routine or extraordinary main-

tenance, we recommend filling the appliance's tank with water

and draining it completely to remove any residual impurities.

8. If the appliance is equipped with a power cord, the latter may only

be replaced by an authorised service centre or professional tech-

nician.

9. It is mandatory to screw on the water inlet pipe of the unit a

safety valve in accordance with national regulations. In coun-

tries which have enacted EN 1487, the safety group must be

calibrated to a maximum pressure of 0,7 MPa and include at

least a cock, check valve and control, safety valve and hydraulic

load cutout.

10. Do not tamper with the overpressure safety device (valve or