Aeotec AEOEZW112 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Aeotec AEOEZW112에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec AEOEZW112 6 페이지.

Installation

Whether it?s for security or intelligence purposes, your sensor:

1. Should be afﬁxed indoors and away from sources of moisture.

2. Placed within 30 meters of another Z-Wave device that is either a gateway or not powered by batteries.

3. The magnet and the main sensor must be less than 1.6cm apart for the small magnet installation or 2.5cm apart for the big magnet installation. Main sensor m

be afﬁxed to the door or window and the magnet must be afﬁxed to the frame. The magnet and the main sensor must separate when the door or window is

opened.

4. Should not be mounted on a metal frame.

Afﬁx your Back Mounting Plate and Magnet to a surface.

The Back Mounting Plate can be afﬁxed using screws or double-sided tape and should be mounted on the apex angle of the door. The Magnet must be afﬁxed u

double-sided tape and can?t exceed the valid range, see the ﬁgure below.

Note:

1. There are 2 types of Magnets (Magnet 1: 30mm×6mm×2mm, Magnet 2: 30mm×10mm×2mm) , the size of magnet 2 is a little larger than magnet 1, so the

magnetism of magnet 2 is stronger than the magnet 1.

2. You can choose to install each one of magnet on the door frame according to your need or the distance between the door and frame, see the ﬁgure below.

3. The Magnets should not be around children to avoid swallowing of the magnets.

When the Back Mounting Plate is afﬁxed by the double-sided tape, wipe the two surfaces clean of any oil or dust with a damp towel. Then when the surface has

completely dried, peel one side of the tape back and attach it to the corresponding section on the rear side of the Back Mounting Plate

http://manual.zwave.eu/backend/make.php?lang=en&sku=AEOEZW112

30-09-2020 13:12

Pagina 2 van 6