ABB 30-050-01 원본 사용 설명서 - 페이지 4

{카테고리_이름} ABB 30-050-01에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB 30-050-01 12 페이지. Emergency stop with indication

2 Overview

In order to fulfil the need for a small and easy to install E-stop, Smile Tina has been developed. The

size of the device makes it possible to be installed wherever needed. With M12 connections or cable

and centralized mounting holes. Smile Tina is very easy to install, especially on aluminium extrusions.

There are three different versions available, either with one or two M12 connections or cable. Two

M12 connectors are used to enable the connection of E-stops in series, which is often used with

dynamic safety circuits fulfilling safety category 4. On the top of the Smile Tina E-stop unit, an LED

indicates the actual status according to the dynamic system. Smile Tina is intended for use in safety

circuits in accordance with EN 60204-1.

Warning!

Carefully read through this entire manual before using the device.

The devices shall be installed by a trained electrician following the Safety regulations, Standards and

the Machine directive.

Failure to comply with instructions, operation that is not in accordance with the use prescribed in these

instructions, improper installation or handling of the device can affect the safety of people and the

plant.

For installation and prescribed use of the product, the special notes in the instructions must be

carefully observed and the technical standards relevant to the application must be considered.

In case of failure to comply with the instructions or standards, especially when tampering with and/or

modifying the product, any liability is excluded.

Smile_Tina_Manual_(English)_v1A

www.jokabsafety.com

2010-10-19