Aeotec MULTISENSOR 6 사용자 설명서 - 페이지 11
{카테고리_이름} Aeotec MULTISENSOR 6에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec MULTISENSOR 6 13 페이지. Z-wave water and flood sensor
Aeotec MULTISENSOR 6에 대해서도 마찬가지입니다: 매뉴얼 (3 페이지), 사용자 설명서 (8 페이지), 매뉴얼 (10 페이지), 사용자 설명서 (13 페이지)
페이지 인쇄
- 1. Resetting Your Multisensor
- 2. Add Your Multisensor to Your Z-Wave Network
- 3. Waking up Your Multisensor
- 4. Setting the Sensitivity of Your Multisensor
- 5. Monitoring Temperature, Humidity, Luminance and Ultraviolet
- 6. Monitoring Motion
- 7. Advanced Functions
- 8. Removing Your Multisensor from a Z-Wave Network
1.
If your Z-Stick is plugged into a gateway or a computer, unplug it.
2.
Take your Z-Stick to your MultiSensor.
3.
Press and hold the Action Button on your Z-Stick for 3 seconds
and then release.
4.
Press the Action Button on your MultiSensor.
5.
If your MultiSensor has been successfully removed from your
network, its LED will blink when you press the Action Button on
the MultiSensor. If the removal was unsuccessful, the LED will
stay solid for a few seconds when you press the Action Button.
6.
Press the Action Button on the Z-Stick to take it out of removal
mode.
If you're using a Minimote:
Remove
1.
Take your Minimote to your MultiSensor.
2.
Press the Remove Button on your Minimote.
12
USB port
3.
Attach your desired mounting accessory. This can be the Back-
Mount Arm. You can affix the Back-Mount Arm via using the
provided KA2.5×20mm screws or Double-Sided Tape.
Double-Sided Tape
Tips: We suggest you choose the second method (using screws to
affix the Back-Mount Arm) would be more stable.
4.
After you have completed the affixing of Back-Mount Arm, you
will need to lock the MultiSensor to the Back-Mount Arm via
turning the MultiSensor.
Battery Holder
Or
9