Ariston JOVIS 80 조립 및 작동 지침 매뉴얼 - 페이지 2

{카테고리_이름} Ariston JOVIS 80에 대한 조립 및 작동 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston JOVIS 80 25 페이지.

GENERAL SAFETY INSTRUCTIONS

1. Read the instructions and warning in this manual carefully, they

contain important information regarding safe installation, use

and maintenance.

This manual is an integral part of the product. Hand it on to the

next user/owner in case of change of property.

2. The manufacturer shall not be liable for any injury to people, ani-

mals or damage to property caused by improper, incorrect or un-

reasonable use or failure to follow the instructions reported in this

publication.

3. Installation and maintenance must be performed by professionally

qualified personnel as specified in the relative paragraphs.

Only use original spare parts. Failure to observe the above instruc-

tions can compromise the safety of the appliance and relieves the

manufacturer of any liability for the consequences.

4. DO NOT leave the packaging materials (staples, plastic bags, ex-

panded polystyrene, etc.) within the reach of children, they can

cause serious injury.

5. The appliance may not be used by persons under 8 years of age,

with reduced physical, sensory or mental capacity, or lacking the

requisite experience and familiarity, unless under supervision or

following instruction in the safe use of the appliance and the haz-

ards attendant on such use. DO NOT permit children to play with

the appliance. User cleaning and maintenance may not be done

by unsupervised children.

6. DO NOT touch the appliance when barefoot or if any part of your

body is wet.

7. Before using the device and after routine or extraordinary mainte-

nance, we recommend filling the appliance's tank with water and

draining it completely to remove any residual impurities.

8. If the appliance is equipped with a power cord, the latter may only

be replaced by an authorised service centre or professional tech-

nician.

9. It is mandatory to screw the water inlet pipe of the unit safety valve

in accordance with national regulations. In countries which have

enacted EN 1487, the safety group must be calibrated to a maxi-

2 / EN