Ariston NEXT EVO X SFT Series 사용자 설명서 - 페이지 14

{카테고리_이름} Ariston NEXT EVO X SFT Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston NEXT EVO X SFT Series 28 페이지. Instantaneous gas water heater
Ariston NEXT EVO X SFT Series에 대해서도 마찬가지입니다: 사용자 설명서 (44 페이지)

페이지 인쇄

INSTALLATION

Before installing the appliance

The appliance heats water to a temperature below boiling.

It should be connected to a domestic water mains supply.

Before connecting the appliance, it is necessary to

perform the following operations:

- Carefully wash the system piping in order to remove

any screw thread or welding residues, or any dirt which

might prevent the appliances from operating correctly.

- Make sure that the appliance is set up for operation with

the type of gas available (read the information on the

packaging label and on the boiler data plate).

- Make sure that there are no obstacles inside flue

exhaust and that it does not contain any discharge

from other appliances, unless the flue is meant to serve

more than one user (in accordance with current legal

requirements).

- Where there is already a connection to existing flue

exhausts, check that these exhausts have been

perfectly cleaned and are without residues, because

any disconnection could obstruct the passage of fumes

and create potentially dangerous situations.

- Make sure that, where unsuitable flue exhausts are

attached, they have been ducted.

- In areas with particularly hard water, limescale may build

up on the components inside the appliance and reduce

its overall efficiency.

C-type appliance, with combustion chambers and air

supply circuits which are completely sealed from the

air outside, do not have any limitations concerning the

ventilation and size of the room in which they are installed.

So that the normal operation of the appliance is not

compromised, the place in which it is installed must be

suitable with regard to the operating limit temperature

value and the appliance should be protected so that it does

not come into direct contact with atmospheric agents.

The appliance must be installed on a solid, non-

combustible, permanent wall to prevent access from the

rear.

When creating a space for the boiler, the minimum

distances (which ensure that various parts of the appliance

may be accessed after it has been installed) should be

respected.

WARNING

No flammable items should be left in the

vicinity of the appliance.

Make sure the installation site and any

systems to which the appliance must be

connected are fully compliant with the

current applicable legislation.

If dust and/or aggressive vapours are

present in the room in which it is to be

installed, the appliance must operate

independently of the air inside the room.

WARNING

The installation and first ignition of the

appliance must be performed by qualified

personnel in compliance with current

national regulations regarding installation,

and in conformity with any requirements

established by local authorities and public

health organisations.

Installation location

Observe the regulations in force, when deciding where to

install the device.

The device must not be installed near heat sources

Do not install the device in environments where

temperatures may reach 0°C

For installation inside furniture, consider that the

maximum temperature of the device jacket is lower

than 85°C and distances required for maintenance

must be respected.

Minimum clearances

In order to allow easy access to the appliance for

maintenance operations.

The appliance must be installed in accordance with the

clearances stated below.