3Com ETHERLINK III 빠른 매뉴얼 - 페이지 2
{카테고리_이름} 3Com ETHERLINK III에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com ETHERLINK III 8 페이지. Lan pc card
3Com ETHERLINK III에 대해서도 마찬가지입니다: 빠른 시작 (2 페이지)
페이지 인쇄
Follow these steps to perform the preinstallation procedure:
1 Turn the power on and boot Windows 95.
2 Click Start in the Windows 95 taskbar, and then click Run .
3 Insert EtherDisk diskette 2 in drive A, and then enter:
a:\preinstl
4 Click OK .
The Preinstall Software screen appears, displaying a list of
available IRQs. Write down these IRQs. You may need this
information if you have a problem installing the NIC.
If your PC does not support Plug and Play, a different screen
appears, confirming that a Plug and Play BIOS is not installed in
your PC.
If this other screen appears, you cannot use this quick guide.
Instead, you must install the NIC using the Custom installation
option within the 3Com Installation Wizard. See Chapter 2 in the
EtherLink III ISA Network Interface Card User Guide for the
Custom installation procedure.
5 Click OK .
The next step is to install the NIC.
Installing the NIC
The following instructions apply to installing the 3C509B NIC in
most PCs. Refer to the manual that accompanied your PC if the
following instructions are not appropriate for your PC.
You must have either one ISA or one EISA slot available in your PC
in which to install the NIC.
CAUTION: Each NIC is packed in antistatic packaging to protect it
during shipment. Before handling the NIC, touch the bare metal
case of your PC. While you are handling the NIC, wear a wrist
strap attached to the PC chassis.
Remove all jewelry from your hands and wrists and use only
insulated or nonconducting tools.