Aeotec ZW187 매뉴얼 - 페이지 11

{카테고리_이름} Aeotec ZW187에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec ZW187 11 페이지. Recessed door sensor gen7
Aeotec ZW187에 대해서도 마찬가지입니다: 사용자 설명서 (9 페이지)

3.5

How to remove the product from Z-Wave network

1. Set your Z-Wave Controller into its 'Remove Device' mode in order to remove the product from your Z-Wave system.

Refer to the Controller's manual if you are unsure of how to perform this step.

2. Make sure the product is powered.

3. Click Action Button once; LED will become flash Red color for 5 seconds.

4. If Removing fails, it will extinguish, without slow fade-in fade-out Red color.

5. If Removing succeeds, it will become slow fade-in fade-out Red color for 10 seconds, and then extinguish. Now, it is

removed from Z-Wave network successfully.

3.6

If the primary controller is missing or inoperable, you may need to reset the device to factory settings.

Make sure the product is powered. To complete the reset process manually, press and hold the Action Button for at

least 22s and release the Action Button when LED becomes slow fade-in fade-out Red color, then Factory Reset is

performed. Contact us for further support if needed.

Note:

1. This procedure should only be used when the primary controller is missing or inoperable.

2. Factory Reset will:

(a) Remove the product from Z-Wave network;

(b) Delete the Association setting;

FCC Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device

may not cause harmful interference, and (2) this device must accept any interference received, including interference

that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's

authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure

condition without restriction.

AEOTEC Engineering Specification

Page 7