Ariston RMC45E-VN 매뉴얼 - 페이지 8
{카테고리_이름} Ariston RMC45E-VN에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston RMC45E-VN 23 페이지. Electric instant water heater
페이지 인쇄
Starting
IMPORTANT:
THE HEATER TANK MUST BE FILLED UP WITH WATER BEFORE TURN
ON THE ELECTRICITY SUPPLY THIS IS TO PREVENT ANY DRY BURNT
DAMAGE TO THE HEATING ELEMENT.
SHOULD TURN OFF THE HEATER BEFORE TURN OFF THE STOP VALVE.
OTHERWISE, IT WILL COME OUT A PERIOD OF HOT WATER IFRESTART
THE HEATER IN SHORT TIME, OR CAUSE CONFUSION ON OPERATION
LOGIC DUE TO SPECIAL DESIGN.
1. Turn on the water supply and the stop valve, and then wait until the water flow
through the hand shower.
2. Switch on the electrical supply and the ELCB lamp will light on.
3. Press the Temperature control knob, the HEATING lamp will light up; the
hot water will come out in a few seconds. The higher the temperature indicator
position, the hotter is the shower.
4. The outlet temperature may not be able to reach the setting temperature if
the incoming water supply from the mains is too cold or the flow rate is too high.
In this case, you can reduce the water flow rate which will lead to increase the
outlet temperature, but it is still not necessarily able to reach the setting
temperature in case the water supply really cold.
5. The built-in ELCB will self-check every time when using the product.
6. The height and the direction of the shower holder are adjustable. Depress
the release button and slide the shower holder to the desired position. Move
the hand shower to the desired angle. A ratchet mechanism in the shower holder
will holds the hand shower in the selected position (fig.4).
7. Press the temperature control knob to turn off.
For constant temperature model:
The outlet temperature might be unstable if the inlet water pressure or the voltage
change sharply.
If inlet temperature higher than the setting temperature, the triangle lamp (
will light up and the unit will stop heating until the inlet temperature back to normal
6
)