Aeotec ZWA044 사용자 설명서 - 페이지 3

{카테고리_이름} Aeotec ZWA044에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec ZWA044 9 페이지. Water sensor

17/06/2021

Quick Start

Installation of Water Sensor 7 Pro.

Open the cover by pressing the clip on the side and pulling the cover upwards.

Insert a fresh 1 * 1/2 AA battery, but pay attention to the polarity

Install your Water Sensor 7 Pro.

The Water Sensor 7 should be placed wherever you want to monitor for possible ﬂooding or leaks. When placing the

Water Sensor 7, consider the direction in which a ﬂood or leak may ﬂow and where it may occur. The contacts of the

Water Sensor 7 probe will detect the liquid, so the probe must be placed so that any ﬂood or leak will come into contact

with it. When the probe contacts come into contact with a liquid, the Water Sensor 7 sends a leak warning to your Z-

Wave Gateway. Make sure that both contacts are capable of detecting leaks or ﬂooding.

Adding your Water Sensor 7 to Z-Wave network.

Z W

Classic Inclusion

1. Set your Z-Wave controller into pairing mode.

2. Triple-click the tamper switch on Water Sensor 7 - this begins to blink five times

3. After completion of the inclusion, the LED will illuminate green for 3 seconds.

4. If you pairing with S2 encryption/security, enter the first 5 digits of the DSK into your controller/gateway/hub

interface when requested.

5. Close the cover

https://help.aeotec.com/support/solutions/articles/6000235950-water-sensor-7-pro-user-guide-zwa019-zwa044-

Water Sensor 7 Pro user guide (ZWA019/ZWA044) : Aeotec Help Desk

Z W

3/9