Ariston ST 100 ProTech 설치, 서비스 및 사용 지침 - 페이지 25

{카테고리_이름} Ariston ST 100 ProTech에 대한 설치, 서비스 및 사용 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston ST 100 ProTech 36 페이지. Unvented hot water storage cylinders
Ariston ST 100 ProTech에 대해서도 마찬가지입니다: 설치 및 사용 설명서 지침 (24 페이지), 사용자 설명서 (16 페이지), 설치, 서비스 및 운영 지침 (34 페이지)

페이지 인쇄

10) Test the operation of the temperature & pressure relief and expansion

valves by lifting/turning the manually operated test lever/cap and

observing that water flows through freely and safely to waste;

11) Check that the discharge pipe is plumbed so that it falls continuously

and that no taps, valves or other shut off devices are installed in the

pipe;

12) Check that all thermostats are set at approximately 60-65°C;

13) DIRECT UNITS. Switch on immersion heater(s) and allow unit to heat

up. Check operation of thermostat(s);

14) INDIRECT UNITS. Fill the indirect (primary) circuit following the boiler

instructions. Switch on the boiler, ensure that the programmer is in the

domestic hot water position. Allow unit to heat up and check operation of

indirect thermostat and motorised valve(s);

15) Check the temperature of the hot water at the nearest outlet and record

in the Benchmark Log Book;

16) Demonstrate operation to user, including operation of temperature &

pressure relief valve and what to do if it operates;

17) Give this manual along with the completed Benchmark Log Book to the

user to retain for future reference and make the customer aware that

periodic checks of the equipment are essential for safety.