Ariston ST 80 ProTech 설치 및 사용 설명서 지침 - 페이지 14

{카테고리_이름} Ariston ST 80 ProTech에 대한 설치 및 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston ST 80 ProTech 24 페이지. Unvented hot water storage cylinders
Ariston ST 80 ProTech에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지), 설치, 서비스 및 운영 지침 (34 페이지)

페이지 인쇄

www.tradeplumbing.co.uk Call Sales On 08708034288

2.11

LECTRICAL

IAGRAM

www.tradeplumbing.co.uk Call Sales On 08708034288

Should the Economy 7 system not to be used, a separate 13 amp supply to

each element will be required. Through a double pole fused isolating switch

having a contact gap of at least 3mm on each pole.The immersion heater

shall be installed with 85°C rubber insulated HOFR-sheathed flexible cable

complying with Table 8 of BS 6141: 1991. Make the connection(s) to the

immersion heater(s) as per F

litre models consult the wiring diagram on the reverse of the inspection

panel.

Single Element

. 2.12

. 2.13

The thermostat(s) on the immersion heater(s) should be adjusted to trip at

60°C. This is the ideal temperature to prolong element life in hard water

areas. Scale on the sheath builds up more rapidly at temperatures above

this causing the element to overheat and premature failure can occur. Higher

temperatures without additional controls would result in scalding.

In addition to the thermostat the thermal cut-out will switch power off to the

element should the thermostat malfunction, causing an excessive rise in

water temperature. The thermal cut-out can be reset manually after the fault

has been corrected.

. 2.12 and F

. 2.13. For High Capacity 500

THERMAL

THERMOSTAT

CUT-OUT

THERMAL

THERMOSTAT

CUT-OUT

THERMAL

THERMOSTAT

CUT-OUT

ELEMENT

3 kW

240V~

DAY ELEMENT

3 kW 240V~

NIGHT ELEMENT

3 kW 240V~

ECONOMY 7