Ariston STI 125 INDIRECT 설치 지침 매뉴얼 - 페이지 3

{카테고리_이름} Ariston STI 125 INDIRECT에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston STI 125 INDIRECT 20 페이지. Type c
Ariston STI 125 INDIRECT에 대해서도 마찬가지입니다: 설치 및 사용 설명서 지침 (24 페이지), 사용자 설명서 (16 페이지)

페이지 인쇄

1.1

ENERAL

NSTRUCTIONS

Supplied By www.heating spares.co Tel. 0161 620 6677

Read the instructions and recommendations in these Installation Instructions

carefully to ensure proper installation, use and maintenance of the appliance.

Keep this manual in a safe place. You may need it for your own reference while our

Servicing Centre technicians or your installer may need to consult it in the future.

This is an appliance for the production of central heating (C.H.).

This appliance must be used only for the purpose for which it is designed.

The manufacturer declines all liability for damage caused by improper or negligent

use.

No asbestos or other hazardous materials have been used in the fabrication of this

product.

Before connecting the appliance, check that the information shown on the data

plate and the table in section 7 comply with the electric, water and gas mains of the

property. You will find the data plate on the reverse of the control panel.

The gas with which this appliance operates is also shown on the label at the bottom

of the boiler.

Do not install this appliance in a damp environment or close to equipment which

spray water or other liquids.

Do not place objects on the appliance.

Do not allow children or inexperienced persons to use the appliance without

supervision.

If you smell gas in the room, do not turn on light switches, use the telephone or any

other object which might cause sparks.

Open doors and windows immediately to ventilate the room.

Shut the gas mains tap (at or adjacent to the gas meter) or the valve of the gas

cylinder and call your Gas Supplier immediately.

If you are going away for a long period of time, remember to shut the mains gas tap

or the gas cylinder valve.

Always disconnect the appliance either by unplugging it from the mains or turning

off the mains switch before cleaning the appliance or carrying out maintenance.

In the case of faults or failure, switch off the appliance and turn off the gas tap. Do

not tamper with the appliance.

For repairs, call your local Authorised Servicing Centre and request the use of

original spare parts. For in-guarantee repairs contact MTS (GB) Limited.

Check the following at least once a year:

1 -

Check the seals for the water connections; replace any faulty seals.

2 -

Check the gas seals; replace any faulty gas seals.

3 -

Visual check of the entire unit.

4 -

Visual check of the combustion process or analysis of combustion by-products

(see section 4.5) and cleaning of the burner if needed.

5 -

If called for by point. 3, dismantling and cleaning of the combustion

chamber.

6 -

If called for by point. 4, dismantling and cleaning of the burner jets.

7 -

Visual check of the primary heat exchanger:

check for overheating in the blade assembly;

clean the exhaust fan if needed.

8 -

Adjustment of the flow rate of the gas: flow rate for lighting, partial load and full

load.

9 -

Check of the heating safety systems:

safety device for maximum temperature (overheat thermostat);

safety device for maximum pressure (safety valve).

10- Check of the gas safety systems:

safety device for lack of gas or flame ionisation (detection

electrode);

safety device for gas cock.

11- Check of the electrical connection (make sure it complies with the instructions

in the manual).

12- General check of the combustion by-products of the discharge/ventilation

system.

13- Check of the general performance of the unit.