ABB ACH580 Series 빠른 시작 매뉴얼 - 페이지 6
{카테고리_이름} ABB ACH580 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB ACH580 Series 15 페이지. Floating point control
ABB ACH580 Series에 대해서도 마찬가지입니다: 설정 방법 (2 페이지)
페이지 인쇄
6 EN – Quick start-up guide
Check that the motor data is correct. Values are predefined
on the basis of the drive size but you should verify that they
correspond to the motor.
Start with the motor type.
• Go to the edit view of a selected row by pressing
•
Scroll the view with
Motor nominal cos Φ and nominal torque are optional.
Press
(Next) to continue.
To change a value in an edit view:
EN
• Use
and
•
Use
and
Press
(Save) to accept the new setting, or press
(Cancel) to go back to the previous view without making
changes.
This step is optional, and requires rotating the motor. Do not
do this if it could cause any risk, or if the mechanical set-up
does not allow it.
To do the direction test, select Spin the motor and press
(Next).
Press the Hand key
and
.
to move the cursor left and right.
to change the value.
Hand
on the panel to start the drive.