Aeotec AEOEZW116 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Aeotec AEOEZW116에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec AEOEZW116 11 페이지. Single nano switch with measuring
Aeotec AEOEZW116에 대해서도 마찬가지입니다: 매뉴얼 (16 페이지)

페이지 인쇄
Aeotec AEOEZW116 빠른 시작 매뉴얼

Prepare for Installation / Reset

Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do
this by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended
to use the primary controller of the previous network to make sure the very device is excluded properly from this network.
Reset to factory default
This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should only be used when the primary controller is inoperable.
Set Parameter 255
Safety Warning for Mains Powered Devices
ATTENTION: only authorized technicians under consideration of the country-specific installation guidelines/norms may do works with mains power. Prior to the
assembly of the product, the voltage network has to be switched off and ensured against re-switching.

Installation

Notes for the wire connection ports:
N ? Power input for neutral
L ? Power input for live
IN ? Input for load power supply