Aeotec Smart Switch 6 사용자 설명서 - 페이지 11
{카테고리_이름} Aeotec Smart Switch 6에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec Smart Switch 6 12 페이지.
Aeotec Smart Switch 6에 대해서도 마찬가지입니다: 매뉴얼 (7 페이지)
페이지 인쇄Be sure to watch for the blink, as it will only blink once very quickly.
Reset your Smart Switch.
If at some stage, your primary controller is missing or inoperable, you may wish to reset all of
your Smart Switch 6 settings to their factory defaults and allow you to pair it to a new
gateway. To do this:
1. Press and hold the Action Button for 20 seconds
2. The LED will change between these colors:
o
Yellow
o
Purple
o
Red (blinks faster and faster)
o
Green (Successful indication of factory reset)
o
Rainbow LED (waiting to pair to new network)
3. When the LED changes to Green state, you may let go of the action button.
4. When the LED changes to a rainbow LED state, it will indicate that it is ready to pair to a
new network.
Firmware Update Smart Switch 6
In the case that you need to firmware update your Smart Switch 6, please refer to this article
here:
https://aeotec.freshdesk.com/solution/articles/6000134294-smart-switch-6-firmware-v1-03-
update
It is currently required to have:
1. Z-Wave USB Adapter that conforms to Z-Wave Standards
2. Windows Operating System (XP, 7, 8, 10)
Additional information on other Gateways uses.