Aeotec Smart Switch 7 매뉴얼 - 페이지 8
{카테고리_이름} Aeotec Smart Switch 7에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec Smart Switch 7 18 페이지.
Aeotec Smart Switch 7에 대해서도 마찬가지입니다: 사용자 설명서 (8 페이지), 매뉴얼 (6 페이지)
3 PRODUCT QUICK START
3.1
Important safety information
Please read this Engineering Specification carefully for correct and effective use.
Failure to follow the recommendations set forth by AEOTEC Limited may be dangerous or cause a violation of the law.
The manufacturer, importer, distributor, and/or reseller will not be held responsible for any loss or damage resulting
from not following any instruction in this guide or in other materials.
3.2
How to install the product
3.3
How to add the product into Z-Wave network
This product supports Security 2 Command Class. While a Security S2 enabled Controller is needed in order to fully use
the security feature. This product can be included and operated in any Z-Wave network with other Z-Wave certified
devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will
act as repeaters regardless of vendor to increase reliability of the network.
3.3.1
SmartStart Learn Mode
SmartStart enabled products can be added into a Z-Wave network by scanning the Z-Wave QR Code present on the
product with a controller providing SmartStart inclusion. No further action is required and the SmartStart product will
be added automatically within 10 minutes of being switched on in the network vicinity.
Indicator Light will become flash white light for 1s indicating the product has been powered, and then become flash
blue light indicating SmartStart Learn Mode starts. It will become constantly bright yellow light after being assigned a
NodeID.
If Adding succeeds, it will bright blue light for 2s and become Load Indicator Mode.
If Adding fails, it will bright red light for 2s and turn back to breathing blue light and then start SmartStart Learn Mode
again.
Note:
The label of QR Code on the product and package are used for SmartStart Inclusion. The Z-Wave DSK Code is at bottom
of the package. Please do not remove or damage them.
3.3.2
Classic Inclusion Learn Mode
1. Set your Z-Wave Controller into its 'Add Device' mode in order to add the product into your Z-Wave system. Refer to
the Controller's manual if you are unsure of how to perform this step.
AEOTEC Engineering Specification
Page 3