Aeotec ZW116 사용자 설명서 - 페이지 18
{카테고리_이름} Aeotec ZW116에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec ZW116 18 페이지. Single nano switch with measuring
Aeotec ZW116에 대해서도 마찬가지입니다: 매뉴얼 (13 페이지)
페이지 인쇄
3.
If the Nano Switch has been successfully added
to your Z-Wave network, its RGB LED will be
solid. If the pairing was unsuccessful, the red
LED will be on for 2 seconds and then remain a
colourful gradient, repeat the instructions above
from step 1.
With your Nano Switch now working as a part of
your smart home, you'll be able to configure it from
your home control software/phone application.
Please refer to your software's user guide for further
instructions on configuring Nano Switch to your
needs.
4 Removing Nano Switch from a Z-Wave
network.
Your Nano Switch can be removed from your Z-Wave
network at any time. You'll need to use your Z-Wave
network's main controller. To set your Z-Wave
controller/gateway into removal mode, please refer
to the respective section within your controller
16
instruction manual.
1.
Set your Z-Wave controller into removal mode.
2.
Press the Action Button on the Nano Switch or
toggle the external manual switch 3 times in fast
succession.
3.
If the Nano Switch has been successfully
removed from your Z-Wave network, its RGB
LED will remain colourful gradient. If the removal
was unsuccessful, the RGB LED will still be solid
(following the state of the output load), repeat the
instructions above from step 1.
5 Advanced functions.
Changing mode on the External Switch/Button
Control.
The Nano Switch can be controlled via 2-state (flip/
flop) external/manual switch, momentary push
button or the 3-way switch. To automatically detect
and set the mode to the appropriate type of manual
17