Aeotec ZW116 매뉴얼 - 페이지 3
{카테고리_이름} Aeotec ZW116에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec ZW116 13 페이지. Single nano switch with measuring
Aeotec ZW116에 대해서도 마찬가지입니다: 사용자 설명서 (18 페이지)
페이지 인쇄
ATTENTION: only authorized technicians under consideration of the country-specific installation
guidelines/norms may do works with mains power. Prior to the assembly of the product, the voltage network has
to be switched off and ensured against re-switching.
Installation
Notes for the wire connection ports:
N ? Power input for neutral
L ? Power input for live
IN ? Input for load power supply
OUT1 ? Output for load 1
OUT2 ? Output for load 2
S1 ? External switch control for load 1
S2 ? External switch control for load 2
1. Shut off the main circuit breaker of your home for safety during the installation and ensure the wires are not
short circuited during the installation which will cause damage to the Nano Switch.
Note: Your home?s main circuit breaker must support the overload protection for safety.
2. Preparing connection wires 14 AWG power wires for Input/ Output. 18 AWG copper wires for external
manual switch. Use the wire stripper cut the metallic part of the connection wire and make sure the length of
the metallic part is about 5mm.
Note: All connection wires needs to be flexible cable.
Wiring diagram of AC120V/230V power input.