3Com Fast EtherLink XL PCI 10/100BASE-TXNetwork Interface Card 빠른 매뉴얼 - 페이지 5
{카테고리_이름} 3Com Fast EtherLink XL PCI 10/100BASE-TXNetwork Interface Card에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com Fast EtherLink XL PCI 10/100BASE-TXNetwork Interface Card 12 페이지. Fast etherlink xl pci 10/100base-tx network interface card
페이지 인쇄
In most PCs, slot 1 and 2 are bus mastering slots. Use slot 1
if possible with the 3C905B-TX NIC. If you have a video PCI
card, install it in the last slot (the one farthest from slot 1).
6 Unscrew the screw holding the PCI slot's backplate
and remove it.
7 Insert the 3C905B-TX NIC into an empty PCI slot,
shown in Figure 2.
Make sure that the NIC is firmly seated in the slot.
Figure 2 Inserting the NIC
8 Secure the NIC with the screw you removed earlier.
To install the Remote Wake-Up connector, see the
user guide.
9 Replace the PC cover and reconnect all previously
connected cables.
10 Turn on the power to the PC.
11 Proceed to the next section, "Connecting to the
Network."
Installing the 3C905B-TX NIC
Screw
3C905B-TX NIC
PCI slot
3