3Com HiPer DSP 시작하기 매뉴얼 - 페이지 12

{카테고리_이름} 3Com HiPer DSP에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com HiPer DSP 17 페이지. Network application card

7 Use a flat-head screwdriver to tighten the screws on the front panel.

8 Cover any unused chassis slots with safety panels.

9 Apply power to the chassis, if power is not already applied.

10 After the NAC boots, verify that the RN/FL (run/fail) LED is green.

If the RN/FL LED does not light, is solid red or flashing

red, there is an error. Refer to the Trouble Clearing section

for more information.

If the RN/FL LED is green, continue configuring the HiPer

DSP NAC. Refer to the Product Reference for configuration

information.

Installation Procedure

2-5