Aeotec WallMote 사용자 설명서 - 페이지 4

{카테고리_이름} Aeotec WallMote에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec WallMote 9 페이지.
Aeotec WallMote에 대해서도 마찬가지입니다: 사용자 설명서 (8 페이지), 빠른 시작 (3 페이지)

29/10/2019

Adding your WallMote to your Z-Wave network.

With your mounting plates prepared to hold each component of your WallMote, it's time to add it to your Z-Wave

network.

1. Let your Z-Wave primary controller/gateway enter into pairing/

2. inclusion mode.

3. Take your WallMote near to your primary controller. Press the Action Button once on your WallMote, the LED will

blink with green color.

4. If your WallMote has been successfully added to your Z-Wave network, its green LED will be solid for 2 seconds and

then off. If the adding was unsuccessful and the red LED will be solid for 2 seconds and then off, repeat the above

steps.

With your WallMote now working as a part of your smart home, you'll be able to configure it from your home control

software or phone application. Please refer to your software's user guide for precise instructions on configuring the

WallMote to your needs.

Attach your WallMote to its Back Mounting plate.

With your WallMote added to the Z-Wave network. It's now time to insert the main unit into the corresponding Back

Mount plate. Put the main unit in the top-left direction on the Back Mounting, and then push the WallMote into the Back

Mounting Plate, the WallMote will be attracted by the magnets on the Back Mount plate, as the figure below shows.

https://aeotec.freshdesk.com/support/solutions/articles/6000176572-wallmote-user-guide-

Aeotec Wallmote user guide : Aeotec Group

4/9