Ariston Genus 27 Plus 설치 지침 매뉴얼 - 페이지 12

{카테고리_이름} Ariston Genus 27 Plus에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston Genus 27 Plus 24 페이지. Type c boiler
Ariston Genus 27 Plus에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지)

페이지 인쇄

1. Technical Information

Fig. 2.9

In Fig. 2.11 below, several different

types of flue systems are shown.

For additional information regarding the

flue accessories, please consult the

Flue Pipe Accessories manual.

Fig. 2.11

Exhaust Type

Coaxial

System

Split

Systems

(*) L = Length of Piping

Maximum Extension

Exhaust/Air

C12 (xx)

4 m

C32 (xx)

4 m

C42 (xx)

4 m

C12 (xy)

34 m

C32 (xy)

34 m

C42 (xy)

34 m

C52 (xy)

56 m

In calculating the lengths of the pipes, the maximum length must also take into con-

sideration the values for the exhaust/air intake end terminals, as well as 90° elbows

for coaxial systems.

The C52 types must comply with the following requirements:

1. The discharge/intake vent pipes must have the same diameter of ø 80 mm.

2. If an elbow is inserted into the discharge/ventilation system, the calculation of the

overall extension must take into consideration the values for each curve, as indi-

cated in the table.

3. The exhaust pipe must extend at least 0.5 m above the ridge of the roof if it is

located on a side other than that for the air intake (this is not obligatory if the

exhaust and air intake pipes are located on the same side of the building).

Fig. 2.10

Use of ø 42 mm Restictor

Diameter of Pipes

on Delivery Side

(mm)

ø 60 /100

ø 80

This procedure must be done as follows:

1 - Remove the air vent intake in the area

indicated in Fig. 2.9, by breaking the

perforated ring.

2 - Use a tool to grasp the lid and remove

it completely.

3 - Clean any burrs or sharp edges with a

knife or an appropriate tool.

Risk of Condensation

L < 1 m

L < 4.5 m

L < 8 m

Forming

L > 6.6 m

L > 5.8 m