Aeotec NanoMote Quad 운영 매뉴얼 - 페이지 4
{카테고리_이름} Aeotec NanoMote Quad에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec NanoMote Quad 9 페이지.
Aeotec NanoMote Quad에 대해서도 마찬가지입니다: 운영 매뉴얼 (10 페이지), 사용자 설명서 (9 페이지), 빠른 시작 매뉴얼 (5 페이지)
페이지 인쇄
network.
1. Insert the LIR2450 battery.
2. Place the device within the direct range of your Z-Wave controller.
3. Set the main controller's adding mode (see the controller's manual).
4. Double click the button quickly, the LED indicator should blink fast.
5. Wait for the adding process to end.
6. Successful adding will be confirmed by the Z-Wave controller's message.
TIP:
!
If you want your NanoMote Quad to be a security device that use
secure/encrypted message to communicate in a Z-Wave network, then a security
enabled Z-Wave controller is
Ⅳ. Z-WAVE NETWORK EXCLUSION
To remove the NanoMote Quad from the Z-Wave network:
1. Insert the LIR2450 battery.
2. Place the device within the direct range of your Z-Wave controller.
3. Set the main controller remove mode (see the controller's manual).
4. Double click the button quickly, the LED indicator should blink fast.
5. Wait for the removing process to end.
6. Successful adding will be confirmed by the Z-Wave controller's message.
V. LOW BATTERY ALARM FUNCTION
NanoMote Quad will send battery report to the lifeline group when button is triggered during
the sleep mode. If the battery level of the NanoMote Quad is less than 20%, the NanoMote
Quad will send a low battery alarm to the main controller.
VI. WAKE UP
Pressing and holding button for 5 seconds and then release so the NanoMote Quad will wake up
itself and send wake-up notification out to Z-Wave Controller. After that, it can be operated to
update parameters, OTA, and detect battery level etc.
VII. CHILD LOCK FUNCTION
Child Lock function. If enable the Child Lock function, the LED indicator will not be on when press
needed.