Ariston SB 150 Indirect 설치 지침 매뉴얼 - 페이지 8

{카테고리_이름} Ariston SB 150 Indirect에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston SB 150 Indirect 20 페이지. Type c

페이지 인쇄

2.9

LUE

ONNECTIONS

. 2.5

Ø 60/100 mm

. 2.6

Supplied By www.heating spares.co Tel. 0161 620 6677

LUE

The provision for satisfactory flue termination must be made in accordance with BS

5440-1.

The appliance must be installed so that the flue terminal is exposed to outside air.

The terminal must not discharge into another room or space such as an outhouse or

lean-to.

It is important that the position of the terminal allows a free passage of air across it at

all times.

The terminal should be located with due regard for the damage or discolouration that

might occur on buildings in the vicinity.

In cold or humid weather water vapour may condense on leaving the flue terminal.

The effect of such "pluming" must be considered.

If the terminal is less than 2 metres above a balcony, above ground or above a flat

roof to which people have access, then a suitable terminal guard must be fitted.

When ordering a terminal guard, quote the appliance model number.

A suitable terminal guard is available from:

TOWER FLUE COMPONENTS

Morley Road

Tonbridge

Kent TN9 1RA

The minimum acceptable spacing from the terminal to obstructions and ventilation

openings are specified in F

The boiler is designed to be connected to a coaxial flue discharge system.

YSTEM

. 2.5.

ERMINAL

OSITION

A - Directly below an openable window or other opening

B - Below gutters, soil pipes or drain pipes

C - Below eaves

D - Below balconies or car-port roof

E - From vertical drain pipes and soil pipes

F - From internal or external corners

G - Above ground or balcony level

H - From a surface facing a terminal

I - From a terminal facing a terminal

J - From an opening in the car port

(e.g. door, window) into dwelling

K - Vertically from a terminal in the same wall

L - Horizontally from a terminal in the same wall

300

200

300

600

1200

1500

300