Ariston CP 059 MD X AUS S 사용 설명서 - 페이지 4

{카테고리_이름} Ariston CP 059 MD X AUS S에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston CP 059 MD X AUS S 16 페이지. Cooker and oven
Ariston CP 059 MD X AUS S에 대해서도 마찬가지입니다: 사용 및 설치 지침 (13 페이지)

페이지 인쇄

Installation

AUS

! Before placing your new appliance into operation please

read these operating instructions carefully. It contains

important information concerning the safe installation and

operation of the appliance.

! Please keep these operating instructions for future

reference. Make sure that the instructions are kept with the

appliance if it is sold, given away or moved.

! The appliance must be installed by a qualified professional

in accordance with the instructions provided.

! Any necessary adjustment or maintenance must be

performed after the cooker has been disconnected from

the electricity supply.

Room ventilation

The appliance may only be installed in permanently-

ventilated rooms, according to current national legislation.

The room in which the appliance is installed must be

ventilated adequately in order to provide as much air as is

needed by the normal gas combustion process (the flow of

air must not be lower than 2 m

The air inlets, protected by grilles, should have a duct

with an inner cross section of at least 100 cm

be positioned so that they are not liable to even partial

obstruction (see figure A).

These inlets should be enlarged by 100% - with a minimum of

200 cm

- whenever the surface of the hob is not equipped with

a flame failure safety device. When the flow of air is provided in

an indirect manner from adjacent rooms (see figure B), provided

that these are not communal parts of a building, areas with

increased fire hazards or bedrooms, the inlets should be fitted

with a ventilation duct leading outside as described above.

Examples of

ventilation holes

for comburant air.

! After prolonged use of the appliance, it is advisable to open

a window or increase the speed of any fans used.

Disposing of combustion fumes

The efficient disposal of combustion fumes should be

guaranteed using a hood which is connected to a safe

and efficient natural suction chimney, or using an electric

fan which begins to operate automatically every time the

appliance is switched on (see figure).

In a chimney stack or branched flue.

(exclusively for cooking appliances)

/h per kW of installed power).

and should

Adjacent

Room to be

Room

Vented

Enlarging the ventilation slot

between window and floor.

Directly to

the Outside

! The liquefied petroleum gases are heavier than air and

collect by the floor, therefore all rooms containing LPG

cylinders must have openings leading outside so that any

leaked gas can escape easily.

LPG cylinders, therefore, whether partially or completely full,

must not be installed or stored in rooms or storage areas

which are below ground level (cellars, etc.). Only the cylinder

being used should be stored in the room; this should also

be kept well away from sources of heat (ovens, chimneys,

stoves) which may cause the temperature of the cylinder

to rise above 50°C.

Positioning and levelling

! The appliance may be installed alongside any cupboards

whose height does not exceed that of the hob surface.

! Make sure that the wall in contact with the back of the

appliance is made from a non-flammable, heat-resistant

material (T 90°C).

To install the appliance correctly:

• Place it in the kitchen, the dining room or the studio flat

(not in the bathroom).

• If the top of the hob is higher than the cupboards, the

appliance must be installed at least 500 mm away from

them.

• I f t h e c o o k e r i s i n s t a l l e d

underneath a wall cabinet, there

HOOD

must be a minimum distance of 420

600

Min.

mm.

mm between this cabinet and the

top of the hob.

This distance should be increased

to 700 mm if the wall cabinets are

flammable (see figure).

• Do not position blinds behind the cooker or less than 200

mm away from its sides.

• Any hoods must be installed in accordance with the

instructions listed in the relevant operating manual.

Levelling

If it is necessary to level the

appliance, screw the adjustable

feet into the places provided on

each corner of the base of the

cooker (see figure).

Electrical connection

THE APPLIANCE MUST BE EARTHED

The hob is designed to work with alternating current

at the supply voltage and frequency indicated on the

rating plate (situated under the hob or at the end of the

instruction booklet). Make sure that the local supply voltage

corresponds to the voltage indicated on the rating plate.