Ariston DB62 지침 책자 - 페이지 3

{카테고리_이름} Ariston DB62에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston DB62 32 페이지. Built-in multifunction double oven

페이지 인쇄

1. General

The appliance is designed for mounting at a safe level

into an open housing which must be secured to the

backing wall.

2. Oven Housing Cabinets

The oven unit housing cabinet dimensions must

comply with Fig. 4 (see Installation Diagrams).

An air gap of 50 mm minimum must be provided at

the rear of any top or bottom cupboards or shelves

Fig. 1 (see Installation Diagrams).

Ventilation must be unobstructed, ie. from adjacent

cabinetry. This can be done by either raising the

base of the cabinets using the adjusting feet (or

spacers) or alternatively by providing a slot in the

cabinet plinth to the dimensions shown overleaf.

The air gap at the rear allows the warmed air to

pass out of the inner cabinet space, but where it is

intended to fit cupboards above the oven unit to

ceiling height it is essential that the warmed air is

exhausted through the front of the cabinet Fig. 1

(see Installation Diagrams).

If an oven unit is installed adjacent to a tall cabinet,

steam escaping from the oven when the door is

opened could condense on, and perhaps stain, the

adjacent surface. To prevent permanent staining,

the adjacent surface should be made of a material

that is heat resistant and easy to clean.

Adjacent tall cabinets should not be deeper than

the oven housing cabinet.

! IMPORTANT, it is essential that the lower cupboard is

constructed in the manner illustrated (see Installation

Diagrams), ie. having side, back and roof panels so

joined as to provide no apertures which could permit

access to the oven unit when installed.

3. Final installation

Using a spirit level, check that the housing cabinet

is level from side to side and from front to back in

its installed position.

Correct any unevenness by placing wooden

packing under the bottom of the cabinet.

Make sure that the cabinet rests firmly on the

cabinet floor without rocking

Before the oven is fitted, the cabinet must be firmly

secured to the backing wall for stability.

The oven unit should now be lifted (by 2 adults)

into the cabinet and pushed fully home.

Finally the oven unit must be secured to the cabinet

by means of the four pozi wash head screws, two

through each side trim.

Remove all packing material from the grill and oven

interior.

List of Loose Items

4 x Pozi Wash Head No. 6 x 15mm screws.