Ariston DN62X AUS 지침 책자 - 페이지 2

{카테고리_이름} Ariston DN62X AUS에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston DN62X AUS 28 페이지. Built-in multifunction double oven

페이지 인쇄

Installation

Please read these instructions fully.

ENSURE THAT THE OVEN IS INSTALLED BY A

QUALIFIED ELECTRICIAN FOLLOWING THE

INSTRUCTIONS BELOW.

Where to put your oven

1. Your oven should not be located adjacent to a gas

hob/heater or eye level grill as flames from the

burners could cause damage to your oven.

2. For your own safety and to get the best results

from your oven it is important to read through this

Handbook before using your oven for the first time

including the "Always" and "Never".

Electrical Requirements

•

For your own safety, we recommend that your cooker

is installed by a competent person - such as one

who is registered with NICEIC (National Inspection

Council for Electrical Installation Contracting). The

cooker should be installed in accordance with the

latest Edition of the IEE Regulations.

WARNINGS

INCORRECT INSTALLATION COULD AFFECT

THE SAFETY OF THE OVEN.

THIS APPLIANCE MUST BE EARTHED.

BEFORE CONNECTING OR INSTALLING THE

OVEN THE ELECTRICITY SUPPLY MUST BE

SWITCHED OFF.

•

THE INSTALLER MUST check that the voltage

shown on the rating plate corresponds with the

house electricity supply.

•

The oven must be supplied via a suitable double

pole isolating switch, having a contact separation

of at least 3 mm in all poles placed in a readily

accessible position adjacent to the unit.

•

The maximum loading for your oven is 5.3kW.

•

If the oven is to be wired into a connector unit this

may be positioned behind the oven provided the

following requirements are met:

i) The connector unit must not project from the wall

more than 25 mm.

ii) The top of the connector must not be more than

350 mm above the base of the oven recess.

•

After unpacking the oven stand it on the packing

base in order to avoid damage.

Electrical connections

•

Remove the terminal cover at the rear base of the

oven. Pass the cable through the cable clamp and

connect to the appropriate terminals provided.

Allow sufficient cable so that the oven can be set

down on the floor whilst still connected up. Tighten

the screws on the cable clamp and replace the

terminal cover. Make mains connections. This

appliance conforms to EN55014 regarding

suppression of Radio and Television reception

interference. Where a double oven is used a 32

amp double pole control switch should be used to

feed the unit using a suitable rated cable. We

recommend that a minimum of 4mm2 PVC insulated

twin and earth cable conforming to B.S. 6004.

•

Where a hob is fitted adjacent to an oven then a 45

amp Double Pole control switch should be used to

feed both units via separate suitably rated cables.

We recommend that a minimum of 4mm2 PVC

insulated twin and earth cable conforming to B.S.

6004.

WARNING: CHILDREN SHOULD NOT BE ALLOWED

TO PLAY WITH THE APPLIANCE OR TAMPER

WITH THE CONTROLS.