Aeotec ZWA039 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Aeotec ZWA039에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec ZWA039 12 페이지. Temperature & humidity sensor

Product Description

This device measures the three air quality parameters temperature, humidity and dew point and reports

them to a central controller. Besides this, the device can directly control groups of other Z-Wave devices

on over- and undershooting a set temperature and/or humidity parameter. This can be used to establish

control loops for temperature and humidity. The device wakes up every 15 minutes to measure the

values and it will send unsolicited reports when values change. Additionally, the device will report all

values on request.

The AërQ Sensor is actively monitoring the danger of mould in a room based on the temperature and

humidity and will issue alarm warnings when critical air conditions met. Wireless Alarm and red and a

green blinking LED will indicate a mould condition. This local LED warning function is also available

when the device is not included in any Z-Wave network and works stand alone.

Please read the user manual before installing the product.

In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make

sure to reset the device into factory default. You can do this by performing an Exclusion operation as

described below in the manual. Every Z-Wave controller is able to perform this operation however it is

recommended to use the primary controller of the previous network to make sure the very device is

excluded properly from this network.

Reset to factory default

This device also allows to be reset without any involvement of a Z-Wave controller. This procedure

should only be used when the primary controller is inoperable.

Keep the button pressed for 10 seconds. Then the green LED will start blinking. Release the button,

when the LED stops blinking. Your device is reset to factory default now.

Safety Warning for Batteries

The product contains batteries. Please remove the batteries when the device is not used. Do not mix

batteries of different charging level or different brands.

Just place the device on any flat surface. Please keep in mind that the temperature may be different in

different locations inside the room. If placed too close to the heating both temperature, humidity and

dew point values may be wrong. The device is IP 20 rated. This means that is must not be exposed to

direct water (rain). It is safe to use the device in a humid environment such as a bathroom or dedicated

washing facility.

Inclusion/Exclusion

On factory default the device does not belong to any Z-Wave network. The device needs to be added to

an existing wireless network to communicate with the devices of this network. This process is

called Inclusion.

Devices can also be removed from a network. This process is called Exclusion. Both processes are

initiated by the primary controller of the Z-Wave network. This controller is turned into exclusion