Ariston FB 82C IX AUS 설치 및 사용 설명서 지침 - 페이지 11

{카테고리_이름} Ariston FB 82C IX AUS에 대한 설치 및 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston FB 82C IX AUS 12 페이지.

페이지 인쇄

Fitting on a Power Supply Cable

Opening the terminal board:

•

Using a screwdriver, prise on the side tabs of the ter-

minal board cover;

•

Pull open the cover of the terminal board.

To install the cable, proceed as follows:

•

Remove the wire clamp screw and the three contact

screws L-N-

•

Fasten the wires beneath the screwheads using the

following colour scheme: Blue (N) Brown (L) Yellow-

Green

•

Fasten the supply cable in place with the clamp and

close the cover of the terminal board.

Connecting the supply cable to the mains

Install a standardised plug corresponding to the load indi-

cated on the data plate. When connecting the cable di-

rectly to the mains, install an omnipolar circuit-breaker with

a minimum contact opening of 3 mm between the appli-

ance and the mains. The omnipolar circuit breaker should

be sized according to the load and should comply with

current regulations (the earth wire should not be inter-

rupted by the circuit breaker).

Inner dimensions of the oven:

Inner Volume of the Oven:

Consumption:

to maintain 200°C for an hour: kWh 0,95

Technical Specifications

Width 43.5 cm

Depth 40 cm

Height 32 cm

56 litres

to reach 200°C: kWh 0,40

total consumption: kWh 1,35

The supply cable should be positioned so that it does not

reach a temperature of more than 50°C with respect to

the room temperature, anywhere along its length.

Before making the connection, check that:

•

The electrical safety of this appliance can only be guar-

anteed if the cooker is correctly and efficiently earthed,

in compliance with regulations on electrical safety. Al-

ways ensure that the earthing is efficient; if you have

any doubts call in a qualified technician to check the

system. The manufacturer declines all responsibility

for damage resulting from a system which has not been

earthed.

•

Before plugging the appliance into the mains, check

that the specifications indicated on the date plate (on

the appliance and/or packaging) correspond to those

of the electrical mains system of your home.

•

Check that the electrical capacity of the system and

sockets will support the maximum power of the appli-

ance, as indicated on the data plate. If you have any

doubts, call in a qualified technician.

•

If the socket and appliance plug are not compatible,

have the socket replaced with a suitable model by a

qualified technician. The latter, in particular, will also

have to ensure that the cross section of the socket

cables are suitable for the power absorbed by the ap-

pliance. The use of adapters, multiple sockets and/or

extensions, is not recommended. If their use cannot

be avoided, remember to use only single or multiple

adapters and extensions which comply with current

safety regulations. In these cases, never exceed the

maximum current capacity indicated on the single

Voltage and Frequency of Power Supply:

This appliance conforms with the following

European Economic Community directives:

73/23/EEC of 19/02/73 (Low Voltage) and subsequent

modifications;

89/336/EEC of 03/05/89 (Electromagnetic

Compatibility) and subsequent modifications;

93/68/EEC of 22/07/93 and subsequent

modifications.

FB 82... : 240V ~ 50/60Hz 3000W

FB 86... : 240V ~ 50Hz 3000W