Ariston FHSB G IX S 사용 설명서 - 페이지 15

{카테고리_이름} Ariston FHSB G IX S에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston FHSB G IX S 48 페이지.

Maintenance and care

Switching the appliance off

Disconnect your appliance from the electricity supply before carrying out

any work on it.

Cleaning the appliance

• The stainless steel or enamel-coated external parts and the rubber seals

may be cleaned using a sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for the removal of stubborn

stains. After cleaning, rinse and dry thoroughly. Do not use abrasive

powders or corrosive substances.

• The inside of the oven should ideally be cleaned after each use, while it is

still lukewarm. Use hot water and detergent, then rinse well and dry with

a soft cloth. Do not use abrasive products.

• All accessories - with the exception of the sliding racks - can be washed

like everyday crockery, and are even dishwasher safe.

! Never use steam cleaners or pressure cleaners on the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge and a non-abrasive

cleaning product, then dry thoroughly with a soft cloth. Do not use rough

abrasive material or sharp metal scrapers as these could scratch the surface

and cause the glass to crack. For more thorough cleaning purposes, the oven

door may be removed:

1. Open the oven door fully (see diagram);

2. Lift up and turn the small levers located on

the two hinges (see diagram);

3. Grip the door on the two external sides

and close it approximately half way. Pull the

door towards you, lifting it out of its slot (see

diagram).

To replace the door, reverse this sequence.

Inspecting the seals

Check the door seals around the oven regularly. If the seals are damaged,

please contact your nearest Service Centre (see Assistance). We recommend

that the oven is not used until the seals have been replaced.

Remplacement de l'ampoule d'éclairage

comme éclairage de la pièce.

Pour changer l'ampoule d'éclairage

du four:

1. Dévissez le couvercle en verre du

boîtier de la lampe.

2. Dévissez l'ampoule et remplacez-

la par une autre de même type :

puissance 25 W, culot E 14.

3. Remontez le couvercle à sa place

(voir figure(.

! Ne pas utiliser la lampe du four