Ariston FI7 871 SC IX A AUS 참조 매뉴얼 - 페이지 10

{카테고리_이름} Ariston FI7 871 SC IX A AUS에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston FI7 871 SC IX A AUS 13 페이지.

페이지 인쇄

MAINTENANCE AND

CLEANING

Make sure that the oven has

cooled down before carrying out

any maintenance or cleaning.

Do not use steam cleaners.

EXTERIOR SURFACES

• Clean the surfaces with a damp microfibre cloth.

If they are very dirty, add a few drops of pH-neutral

detergent. Finish off with a dry cloth.

• Do not use corrosive or abrasive detergents. If any of

these products inadvertently comes into contact with

the surfaces of the appliance, clean immediately with

a damp microfibre cloth.

INTERIOR SURFACES

• After every use, leave the oven to cool and then

clean it, preferably while it is still warm, to remove

any deposits or stains caused by food residues. To

dry any condensation that has formed as a result of

cooking foods with a high water content, leave the

oven to cool completely and then wipe it with a cloth

or sponge.

CLEANING THE REAR WALL AND THE CATALYTIC PANELS

This oven is equipped with special catalytic liners that

facilitate cleaning of the cooking compartment thanks

to their special self-cleaning coating, which is highly

porous and able to absorb grease and grime.

These panels are fitted to the shelf guides: When

repositioning and then refitting the shelf guides,

make sure that the hooks at the top are slotted into

the appropriate holes in the panels.

REPLACING THE LAMP

Disconnect the oven from the power supply.

. Unscrew the cover from the light, replace the bulb

and screw the cover back on the light.

Reconnect the oven to the power supply.

Do not use wire wool, abrasive

scourers or abrasive/corrosive

cleaning agents, as these could

damage the surfaces of the

appliance.

• Clean the glass in the door with a suitable liquid

detergent.

• The oven door can be removed to facilitate cleaning.

• The top heating element of the grill can be lowered

to clean the upper panel of the oven. Remove the

lateral shelf guides, then pull the heating element out

a little and lower it. To reposition the heating element,

lift it up, pulling it slightly towards you, making sure it

comes to rest on the lateral supports.

ACCESSORIES

Soak the accessories in a washing-up liquid solution

after use, handling them with oven gloves if they

are still hot. Food residues can be removed using a

washing-up brush or a sponge.

To make best use of the catalytic panels' self-cleaning

properties, we recommend heating the oven to 200 °C

for around one hour using the "Convection Bake"

function. The oven must be empty during this time.

Then leave the oven to cool down before

removing any remaining food residues using

a non-abrasive sponge.

Please note: Using corrosive or abrasive cleaning agents,

stiff brushes, pan scourers or oven sprays could damage the

catalytic surface and compromise its self-cleaning properties.

Please contact our After-sales Service if you require

replacement panels.

Please note: Only use 25-40W/230V type E-14, T300°C

incandescent lamps, or 20-40W/230 V type G9, T300°C

halogen lamps. The bulb used in the product is specifically

designed for domestic appliances and is not suitable for

general room lighting within the home (EC Regulation

244/2009). Light bulbs are available from our After-sales

Service.

- If using halogen bulbs, do not handle them with your bare

hands as your fingerprints could cause damage. Do not use

the oven until the light cover has been refitted.

Download the Use and Care Guide from

www.aristonchannel.com for more information

Wear protective gloves.

The oven must be disconnected

from the mains before carrying

out any kind of maintenance

work.