Ariston FK 617 X AUS 사용 설명서 - 페이지 10

{카테고리_이름} Ariston FK 617 X AUS에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston FK 617 X AUS 12 페이지. 60cm 6 function built in oven
Ariston FK 617 X AUS에 대해서도 마찬가지입니다: 치수 및 사양 (2 페이지)

페이지 인쇄

Care and maintenance

Switching the appliance off

AUS

Disconnect your appliance from the electricity supply

before carrying out any work on it.

Cleaning the appliance

• Slight differences in colour on the front of the oven

are due to the different materials used, i.e. glass,

plastic or metal.

• Any shady areas resembling grooves on the oven

door glass are caused by reflections from the oven

light.

• The enamel is branded at very high temperatures.

This process may cause colour variations. This is

normal and will not affect appliance operation in any

way. The thin edges of the sheet metal cannot be

entirely enamelled and may therefore appear to be

unfinished. This will not affect the rust protection.

• The stainless steel or enamel-coated external parts

and the rubber seals may be cleaned using a

sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for the

removal of stubborn stains. After cleaning, rinse and

dry thoroughly. Do not use abrasive powders or

corrosive substances.

• The inside of the oven should ideally be cleaned

after each use, while it is still lukewarm. Use hot

water and detergent, then rinse well and dry with a

soft cloth. Do not use abrasive products.

• All accessories - with the exception of the sliding

racks - can be washed like everyday crockery, and

are even dishwasher safe.

! Never use steam cleaners or pressure cleaners on

the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge

and a non-abrasive cleaning product, then dry

thoroughly with a soft cloth. Do not use rough abrasive

material or sharp metal scrapers as these could

scratch the surface and cause the glass to crack.

For more thorough cleaning purposes, the oven door

may be removed:

1. Open the oven door fully (see diagram).

2. Use a screwdriver to lift up and turn the small levers

F located on the two hinges (see diagram).

Only available in certain models.

3. Grip the door on the two

outer sides and close it

approximately half way. Pull the

door towards you, lifting it out

of its slot (see diagram). To

replace the door, reverse this

sequence.

Inspecting the seals

Check the door seals around the oven regularly. If the

seals are damaged, please contact your nearest

Service Centre (see Assistance). We recommend that

the oven is not used until the seals have been

replaced.

Replacing the light bulb

To replace the oven light bulb:

1. Remove the glass cover of the lamp-holder.

Sliding rack kit assembly

To assemble the sliding racks:

Left

Right guide

guide rail

rail

2. Unscrew the

light bulb and

replace it with a

similar one:

Wattage 25 W,

cap E 14.

3. Replace the

glass cover (see

diagram).

1. Remove the two

frames, lifting them

away from the spacers

A (see figure).

2. Choose which shelf to

use with the sliding rack.

Paying attention to the

direction in which the

sliding rack is to be

extracted, position joint

B and then joint C on the

frame.