Aeotec Z-Stick Gen5 매뉴얼 - 페이지 8

{카테고리_이름} Aeotec Z-Stick Gen5에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec Z-Stick Gen5 11 페이지. Z-wave usb adapter
Aeotec Z-Stick Gen5에 대해서도 마찬가지입니다: 매뉴얼 (2 페이지), 사용자 설명서 (5 페이지)

페이지 인쇄

SUPPORT_ZW_SET_WUT_TIMEOUT

SUPPORT_ZW_SUPPORT9600_ONLY

SUPPORT_ZW_TYPE_LIBRARY

SUPPORT_ZW_WATCHDOG_DISABLE

SUPPORT_ZW_WATCHDOG_ENABLE

SUPPORT_ZW_WATCHDOG_KICK

SUPPORT_ZW_WATCHDOG_START

SUPPORT_ZW_WATCHDOG_STOP

SUPPORT_ZW_NVR_GET_VALUE

SUPPORT_FUNC_ID_CLEAR_TX_TIMERS

SUPPORT_FUNC_ID_GET_TX_TIMERS

5.4 Installation and Maintenance Application (IMA) feature

1. When the Z‐Stick acts an independent/secondary controller that has been un‐plugged from the USB host,

it also can measure the network health for each device in the network. The different colour of LED on the

Z‐Stick indicates the communication quality between the Central Controller and devices in the network.

Short press the Action Button 5 times, if the colour of LED is changed to purple and then it follows with

fast blink, which means it goes into the IMA feature. The colour of LED will be changed according to the

network health level. If the colour of LED is changed to green, which means the current communication

quality is more than 95% on ‐7dBm. If the colour of LED is changed to yellow, which means the current

communication quality is more than 95% on 0dBm. If the colour of LED is changed to purple, which

means the current communication quality is less than 95% on 0dBm. If the colour of LED is changed to

red, which means the current communication has failed.

Short press the Action Button 5 times again, the Z‐Stick will automatically exit the IMA feature.

2. When the Z‐Stick is in Serial API‐Mode and acts a primary controller, it can measure the network health

for each device in the network. The different colour of LED indicates the communication quality between

the Z‐Stick Controller and devices in the network.

Install the IMA tool software first (note: the IMA tool can be downloaded from here:

http://www.aeotec.com/support). Select the node device and then click the IMA test button to start the

IMA test between the Central Controller and the node devices. Your IMA tool client will receive the test

result and use different colour of LED icon to indicate the network health level, its colour will be changed

follow with the change of network health level.