Aeotec AEOEZW116 매뉴얼 - 페이지 3

{카테고리_이름} Aeotec AEOEZW116에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec AEOEZW116 16 페이지. Single nano switch with measuring
Aeotec AEOEZW116에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (11 페이지)

페이지 인쇄

30-09-2020 13:25

by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform

the primary controller of the previous network to make sure the very device is excluded properly from this network.

Reset to factory default

This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should only be u

Set Parameter 255

Safety Warning for Mains Powered Devices

ATTENTION: only authorized technicians under consideration of the country-speciﬁc installation guidelines/norms m

assembly of the product, the voltage network has to be switched off and ensured against re-switching.

Installation

Notes for the wire connection ports:

N ? Power input for neutral

L ? Power input for live

IN ? Input for load power supply

OUT1 ? Output for load 1

OUT2 ? Output for load 2

S1 ? External switch control for load 1

S2 ? External switch control for load 2

1. Shut off the main circuit breaker of your home for safety during the installation and ensure the wires are not shor

damage to the Nano Switch.

Note: Your home?s main circuit breaker must support the overload protection for safety.

2. Preparing connection wires 14 AWG power wires for Input/ Output. 18 AWG copper wires for external manual sw

the connection wire and make sure the length of the metallic part is about 5mm.

Note: All connection wires needs to be ﬂexible cable.

Wiring diagram of AC120V/230V power input.

http://manual.zwave.eu/backend/make.php?lang=en&sku=AEOEZW116

Pagina 3 van 16