Aeotec AEOEZW116 매뉴얼 - 페이지 7
{카테고리_이름} Aeotec AEOEZW116에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec AEOEZW116 16 페이지. Single nano switch with measuring
Aeotec AEOEZW116에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (11 페이지)
페이지 인쇄
Inclusion/Exclusion
On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existin
devices of this network. This process is called Inclusion.
Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the
controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a spe
Inclusion
1. Install the device according to the instructions.
2. Press the button 2 times quickly on the Nano Switch.
Exclusion
1. Press the button once on the Dual Nano Switch.
Quick trouble shooting
Here are a few hints for network installation if things dont work as expected.
1. Make sure a device is in factory reset state before including. In doubt exclude before include.
2. If inclusion still fails, check if both devices use the same frequency.
3. Remove all dead devices from associations. Otherwise you will see severe delays.
4. Never use sleeping battery devices without a central controller.
5. Dont poll FLIRS devices.
6. Make sure to have enough mains powered device to benefit from the meshing
Association - one device controls an other device
Z-Wave devices control other Z-Wave devices. The relationship between one device controlling another device is c
http://manual.zwave.eu/backend/make.php?lang=en&sku=AEOEZW116
30-09-2020 13:25
Pagina 7 van 16