Ariston MBA 3311 and use 설치 및 사용 설명서 - 페이지 7

{카테고리_이름} Ariston MBA 3311 and use에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston MBA 3311 and use 17 페이지. Fridge/freezer combined

Ice trays

This new concept of ice trays is an exclusive Merloni patent.

The fact that they are situated on the inner door of the

freezer compartment ensures greater ergonomics and

cleanliness: the ice no longer comes into contact with the

food placed inside the freezer compartment; furthermore,

the dripping of the water during filling is avoided (a lid to

cover up the hole after filling with water is also provided).

To remove the ice trays from

their housings, push the tray

upwards and then pull it out

(fig. 5). To put the tray back

in place, insert the top part

into the special housing and,

once in a vertical position,

just let it drop into place.

Instructions for use (Fig. 6)

Fill up the tray with water via the special hole up to the level

indicated (MAX WATER LEVEL), taking care not to exceed it:

inserting more water than is necessary will lead to the

formation of ice which could obstruct the exit of the ice cubes.

If you have used an excessive amount of water, you will have

to wait until the ice has melted, empty out the tray and re-fill

it with water.

Once you have filled the ice tray up with water through the

hole indicated, turn it by 90 °. Thanks to the connected

compartments, the water fills up the special shapes, after

which you can cover the hole up with the special cap and

place the ice tray in the inner door of the freezer

compartment.

Fig. 5

Once the ice has formed, all you need to do is to knock the

tray against a hard surface so that the ice cubes come away

from their housing and come out of the same hole used to

fill the tray with water. To make it easier for the ice cubes to

come out, wet the outside of the tray.

WARNING: every time you fill up the ice tray with water ,

make sure that the same is completely empty and that there

are no traces of ice left inside it.

The minimum time required for ice to form well is

approximately 8 hours.

Fig. 6

MAX

WATER LEVEL