Ariston CISTD 640 Series 사용 설명서 - 페이지 4

{카테고리_이름} Ariston CISTD 640 Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston CISTD 640 Series 14 페이지.
Ariston CISTD 640 Series에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지)

페이지 인쇄

It is recommended that you follow the guidelines

below:

Only use the appliance to cook food, avoiding all other

uses;

Check the condition of the appliance after it has been

unpacked;

Disconnect the appliance from the power supply in the

event of malfunction and always before cleaning or

maintenance;

The following instructions are intended for the installer so

that the installation and maintenance procedures may be

followed in the most professional and expert manner

possible. Important: Disconnect the appliance from the

electrical supply before performing any maintenance

or regulation upkeep work.

Positioning the Cooktop

Important: this unit may be installed and used only in

permanently ventilated rooms in accordance with British

Standard Codes Of Practice: B.S. 6172 / B.S. 5440, Par.

2 and B.S. 6891 Current Editions. The following

requirements must be observed:

a) The room must be fitted with a ventilation system which

vents smoke and gases from combustion to the outside.

This must be done by means of a hood or electric

ventilator that turns on automatically each time the hood

is operated.

In a chimney stack or branched flue.

(exclusively for cooking appliances)

b) The room must also allow for the influx of the air needed

for proper combustion. The flow of air for combustion

purposes must not be less than 2 m³/h per kW of installed

capacity. The supply of said air can be effected by means

of direct influx from the outside through a duct with a

inner cross section of at least 100 cm² which must not be

able to be accidentally blocked. Those appliances which

are not fitted with a safety device to prevent the flame

from accidentally going out must have a ventilation

opening twice the size otherwise required, i.e. a minimum

of 200cm² (Fig. A). Otherwise, the room can be vented

indirectly through adjacent rooms fitted with ventilation

Installation Instructions for built-in

Directly to the Outside

When not in use, disconnect the appliance from the

power supply and turn off the gas valve (if present);

Always check to make sure that the control knobs are

on the "•"/"

" setting when the appliance is not in use;

Cut the power supply cord after disconnecting it from

the electrical mains when you decide to no longer use

the appliance.

•

The manufacturer will not be held liable for any

damages arising out of : incorrect installation or

improper, incorrect or unreasonable use..

ducts to the outside as described above, as long as the

adjacent rooms are not shared areas, bedrooms or

present the risk of fire (Fig. B).

Detail A

Examples of ventilation holes

for comburant air.

Fig. A

c) Intensive and prolonged use of the appliance may ne-

cessitate supplemental ventilation, e.g. opening a window

or increasing the power of the air intake system (if

present).

d) Liquidified petroleum gases are heavier than air and, as

a result, settle downwards. Rooms in which LPG tanks

are installed must be fitted with ventilation openings to

the outside in order to allow the gas to escape in the

event of a leak. Therefore, LPG tanks, whether empty or

partially full, must not be installed or stored in rooms or

spaces below ground level (cellars, ect.). It is also a good

idea to keep only the tank currently being used in the

room, making sure that it is not near sources of heat

(ovens, fireplaces, stoves, etc.) that could raise the internal

temperature of the tank above 50°C.

Installation of Built-in Cooktops

The appliance can be installed next to furniture units which

are no taller than the top of the cooker hob. The wall in

direct contact with the back panel of the cooker must be

made of non-flammable material. During operation the

back panel of the cooker could reach a temperature of

50°C above room temperature. For proper installation of

the cooker, the following precautions must be taken:

a) If the cabinet(s) located next to the cooktop are higher

than the cooktop itself, the cabinet(s) must be installed

at least 600 mm from the edge cooktop;

b) Hoods must be installed in accordance with the

instructions contained in the installation manual for the

hoods themselves, and no less than 650 mm from the

Adjacent

Room to be

Room

Vented

Enlarging the ventilation slot

between window and floor.

Fig. B