Ariston CISTD 640 Series 사용 설명서 - 페이지 7

{카테고리_이름} Ariston CISTD 640 Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston CISTD 640 Series 20 페이지.
Ariston CISTD 640 Series에 대해서도 마찬가지입니다: 사용 설명서 (14 페이지)

페이지 인쇄

Start-up and use

! The position of the corresponding gas burner is shown

on every knob.

Gas burners

Each burner can be adjusted to one of the following

settings using the corresponding control knob:

•

Off

Maximum

Minimum

To turn on one of the burners, place a lighted match or

lighter near the burner, press the knob all the way in and

turn it anti-clockwise to the "High" setting.

On those models fitted with a safety device (F), the knob

must be pressed in for about 6 seconds until the device

that keeps the flame lit warms up.

On those models fitted with an ignitor, the ignition button,

identified by the

symbol, must first be pressed and

then the corresponding knob pushed all the way in and

turned anti-clockwise to the "High" setting.

Some models are equipped with an ignition button

incorporated into the control knob. If this is the case, the

ignitor is present, but not the button.

To light a burner, simply press the corresponding knob all

the way in and then turn it anti-clockwise to the "High"

setting, keeping it pressed in until the burner lights.

! If a flame is accidentally extinguished, turn off the control

knob and wait for at least 1 minute before trying to relight

it.

To switch off the burner, turn the knob in a clockwise

direction until it stops (when reaches the "•" position).

Practical advice on using the burners

To ensure the burners operate efficiently:

• Use appropriate cookware for each burner (see table)

so that the flames do not extend beyond the bottom of

the cookware.

• Always use cookware with a flat base and a cover.

• When the contents of the pan reach boiling point, turn

the knob to minimum.

Burner

ø Cookware diameter (cm)

Fast (R)

Semi-Fast (S)

Auxilliary (A)

Mini WOK (MW)

To identify the type of burner, refer to the designs in the

section entitled, "Burner and Nozzle Specifications".

24 – 26

16 – 20

10 – 14

24 – 26