Whirlpool 1CWTW4740 사용 및 관리 매뉴얼 - 페이지 4

{카테고리_이름} Whirlpool 1CWTW4740에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 1CWTW4740 28 페이지.
Whirlpool 1CWTW4740에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (28 페이지)

페이지 인쇄

LID LOCKED

To allow for proper spin operation, the lid

will lock and the Lid Lock light will turn on.

This light indicates that the lid is locked

and cannot be opened.

If you need to open the lid, press

START/Pause/Unlock. The lid will

unlock once the washer movement

has stopped. This may take several

minutes if the load was spinning at

high speed. Press START/Pause/

Unlock again to resume the cycle.

CYCLE STATUS INDICATORS

The Cycle Status Lights show the progress of a cycle.

At each stage of the process, you may notice sounds or

pauses that are different from traditional washers.

FILL/SENSING

When the START/PAUSE button is pressed, the washer

will fill to the selected water level. If the lid is closed

when the machine is done filling the lid will lock and the

machine will begin operation.

If the lid is open when the water stops entering the

machine, the cycle will not begin until the lid has been

closed and the START/PAUSE button is pressed. If the

cycle has not been started within 10 minutes of the water

filling the washer, the washer will pump out the water.

NOTE: Avoid opening lid during Fill/Sensing phase.

The sensing process will start over when the washer is

restarted. The sensing light may also come on during the

Soak and Wash portions of the cycle. This is normal. To

restart the washer after the lid has been opened press

start.

WASH

You will hear the agitator moving the load. The motor

sounds may change at different stages in the cycle.

The wash time is determined by the selected soil level.

RINSE

You will hear sounds similar to the wash cycle as the

washer rinses and moves the load. You may hear the

motor turning on briefly (short hum) to move the basket

while filling. Fabric softener will be added if the Fabric

Softener Added-Yes option was selected.

Some cycles use spray rinsing. After draining and

spinning out wash water, the washer will continue to

spin and spray in rinse water for the entire rinse time.

SPIN

The washer spins the load at increasing speeds for

proper water removal, based on the selected cycle

and spin speed.

DONE

Once the cycle is complete, this light will come on.

Remove the load promptly for best results.