Whirlpool 1CWTW4840YW1 설치 지침 매뉴얼 - 페이지 7
{카테고리_이름} Whirlpool 1CWTW4840YW1에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 1CWTW4840YW1 16 페이지.
Whirlpool 1CWTW4840YW1에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (28 페이지)
페이지 인쇄
1 1.
Check
for leaks
C
Turn on water faucets to check for leaks. A small amount of
water may enter washer. It will drain later.
q 2.
Secure
drain hose
Laundry Tub
Standpipe
4.5"
(114mrn)!
i
Y
,,_,
k
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with cable tie.
LEVEL
WASHER
IMPORTANT:
Level washer properly to reduce excess noise
and vibration.
3.
Check
levelness
of washer
Place level here
Move the washer to its final location. Place a level on top
edges of washer. Use side seam as a guide to check levelness
of sides. Check levelness of front using lid, as shown. Rock
washer back and forth to make sure all four feet make solid
contact with floor. If washer is level, skip to step 15.
Not Level
LEVEL
Not Level
If washer is not level, use a 9/16" or 14 mm open-end or
adjustable wrench to turn jam nuts clockwise on feet until they
are about 1/2" (13 mm) from the washer cabinet. Then turn the
leveling foot clockwise to lower the washer or counterclockwise
to raise the washer. Recheck levelness of washer and repeat
as needed.
HELPFUL TIP: You may want to prop up front of washer
about 4" (102 ram) with a wood block or similar object that
will support weight of washer.